Re: ProLock spindle locking mech
|
Michael,
No luck on the drawing all my old emails are blank. Searching finds the ProLock emails but there is no content.
Joe
toggle quoted message
Show quoted text
Sounds good – hopefully we can get the drawing from joe and they can link back to what they made.?? Then we can see who all is interested - ? ? I too would be interested in a ProLock for my 1 1/4” spindle. ?It sounds like this is a special order project. ?If a group purchase happens, just tell me where and when to send $$. Thanks, aabj@... ?? I have two 1 ?” spindles and would like two if we need a group order…joe ? ? Thanks joe!! ?Was it a stock model - did you have to order anything special ? ? I don’t mind ordering 4 And seeing if others are interested?
Michal,? How was the class? ?I wish I was still woodworking just so I would have an excuse to go hang out with Ultimate Joe in Ouray, CO. When I ordered the ProLock 1 1/4” spindle caps we had to order 4 to make a minimum custom order. I ordered them directly from ProLock and picked them up at LIGNA that year.? ?
? Hey Folks – I had seen a thread about the ProLock spindle locks and know that Joe D had ordered his for a 1 ?” shaper spindle.? I have a K700Z and saw these recently at the Rangate joinery class and was hoping to get one.?? Can anyone direct me to a source?? I did try to see if I could message Joe but could not figure out how to do that on the forum -?
?
|
