开云体育

I haven’t tried it personally but if I was in the same boat I would have a hard look at the sawstop jobsite saw and try to give it a run side by side with the others. I have the DEWALT and no

Mark, Love that dovetail detail for parts that dont fit on the 3d bed. I will have to remember that trick for future projects. What software are you using for your design? Sorry if you already

If you made your own roof and want a backer for your fascia board at the ends of the rafters, you usually ripped the edge of this backer to match the slope of the roof. A job site table saw will help.

This looks great, will your ZCI work on a new Kappa 400 I have coming with the led scoring lights? Sure would like a ZCI option on my new saw.

Greg, Since the tablesaw motor works in the shaper connector and position, at least you know that your motor is good. ?Since you have changed out the selector switch and it’s doing the same thing,

Now that I have Brian’s parallel arms on the slider, I never move the original c31 fence from the jointer. ?Today I forgot to make sure it was tighten down to the rail before I lifted the table to

Anthony, I am not sure if your dad will work on anything large in size. The dewalt and bosch contractor saws are table top models, correct? At least these are the most common. Anyhow, just curious if

I own a Bosch jobsite saw, it has many good features and performs well. One of the few negatives are the slots for the mitre gauge. They are well under standard size, and only fit the simple gauge

Greg, For switches, just use the continuity test. Each ON and OFF switch has a redundant terminal on my machine. Just put the meter probes in the unused holes and look for short (red NC) or open

one consideration is? will there be heights involved.? If so get a saw that you won't be too off-put when it takes a 30 foot header.

Greg, From what I gather, for each motor circuit, there is a connector between the selector switch and the motor. This is where you plugged shaper motor into table saw cable from selector switch and

Hi Imran, What is the connector? I took the wires off the stop switches for my table saw (the factory installed switch and one I installed to operate the saw from the sliding table).? With the wires

Mark, That looks great. BTW, plastic is safer than metal to have around the blade. Are you having the parts milled (i think you mentioned AL) because some portions of the design are too thin to be

Mark, Unfortunately it is true that the blade tilt axis is not fixed, you use the term zero tilt. The saw unit is hung at the edge of the cast iron from 2 pins (one in front and the other in rear).

Welp looks like I am ready to have metal cut. - The scoring section was to long to fit on the 3d print bed so I made it in 2 pieces and connected it with a half lap dovetail. - I modified the pockets

Imran, missed your question below about measurement when blade tilted. Haven't checked but it should as it is zero tilt, you sure the k975 isn’t a zero tilt? Regards, Mark

Anthony ,,,,Erica takes 30 mm bore as does Elu flip saw! martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

My understanding is the hard stops are set within a certain distance from/near the limit switches if the hard stops are set to far the motor actually has enough power to pull the brackets off at the

Mark, if you use the hard stops, then force the trunion to go beyond the limits, the system will disable. I did this a few months ago, forcing the trunion to minus 1 degree, and it hit the stop and

I had a Bosch for a number of years and used it for everything until i bought my first felder in 2018. I liked it and it worked well -