Re: Job site saw recommendation?
|
I haven¡¯t tried it personally but if I was in the same boat I would have a hard look at the sawstop jobsite saw and try to give it a run side by side with the others. I have the DEWALT and no complaints on that. It was inexpensive, good eneough power, and the
fence is quite stable. ?I also bought it years ago before the sawstop was available. But after using a slider and hold downs, when I do use it I am getting a lot closer to a blade than I am comfortable with. Seems to have excellent reviews as well.?
Michael Tagge
Built Custom Carpentry?
Get
toggle quoted message
Show quoted text
On Wed, Jan 20, 2021 at 10:39 PM, imranindiana wrote:
Miter saw or circular saw
If you made your own roof and want a backer for your fascia board at the ends of the rafters, you usually ripped the edge of this backer to match the slope of the roof. A job site table saw will help. A circular saw can do the job, but on 12 ft long 2x6 this
is not an easy job.
Bill
|
