Hi Imran,
What is the connector?
I took the wires off the stop switches for my table saw (the factory installed switch and one I installed to operate the saw from the sliding table).? With the wires dangling, as expected, the entire machine would not operate.? It was as if the a stop button was N/O.? I then tied the wires together, avoiding the switches, and, just as expected, the same malfunction occurred.?
I did notice, however, that the K-2 relay closed.? But K-1, which is downstream and latches to send the 3 phases to the motors, did not close, so no action on that motor.
Will the strangeness ever cease.
Tomorrow, time permitting, I'm going to review every wire that I diagrammed to see where the "as is" diverges from the Felder wiring diagram.
Thanks again, Imran!
