开云体育

From my perspective, and specifically with regard to Felder, great service is a matter of the individual more than the culture of the company. Carl Knapp exemplifies good support, and seems to thrive

Hi Woodworkers There was some recent activity about shapers and tooling which was really good, thank you.? There doesn't appear to be a lot of good info on using shapers and tooling.? One Canadian

Have fun Dave Davies [email protected]> wrote: -- Dave & Marie Davies www.myfinishingtouch.com 318-219-7868

?

I think Laguna has always been the leader in bad service. D

Well.... a recent thread mentioned the terrible support a Felder owner received when his machine came damaged, yet I and others have had excellent interactions with Carl from Felder. My comment on

Joe, I have had the same experience as you have.? Carl has been great for Felder and SCM so far has been great also with Sam.? I called Felder a few times for support and they were good.? Shipping,

> > I’m at a point in life where customer service/support is a priority. We > all see horror stories here on terrible support. I personally have had > great phone support from Carl my Felder rep.

I use them on drawers and doors, and let me know what you find. I think I got my last batch from Hafele and they have worked well on the doors, but for some reason they keep sliding around and falling

You're looking at the wrong size the 2632 is giant, 1.it's way to big for maneuvering inside a shop 2.even when collapsed it's still tall, and climbing up and down will be tiring 3.wieghs 5000lbs so

3M bumpers tend to last the longest. If you want a more permanent solution you’ll need bumpers with a tenon that mount in a 3 or 5 mm hole. They are more expensive and time consuming to install

I am building a kitchen for my daughter. ?Shaker painters doors. ?I will use silicone bumpers on the doors. Assume I should for the drawer fronts too? ?Does anyone have any favorites that don’t

I'm a member of Sawmillcreek.org and a moderator on Canadianwoodworking.com Regards, Rod.

Jay, That's a beautiful machine. Just one thing, wondering if you can talk to my wife and convince her to welcome it into our family? Thanks? Lol,? ?Tom Ruth

Hey! 2022 felder k740 with 2800mm sliding table (xroll) I need som help to figure out what to do about my sliding table. I’ve always gotten a curved cut when straight line ripping sheet goods. But I

Aren’t you measuring the wrong board? Lol. Elwin

Thanks for the photos. As has been commented on before, some people don’t have an issue with the bat ears, others do. That said, my bat ears are bigger than your bat ears. ? ? David Best

Having yet to actually mount the Felder dado set and make some cuts, I figured this would be a good way to do some tests and see for myself the "bat ears". Each dado measures 7mm H x 12mm W I cut some

Hi, I find the following for the 125mm rebate head 1) it fits below the table 2) the radius is small enough to match most furniture requirements 3) there are many bearing type guide rings at, and

If I have a choice I always adjust the non hinge side For the A3 you put a 0.15mm feeler gauge under the straight edge at the far end of the hinge side of the outfeed table the raise the infeed table