开云体育

Brian I was trained to set the height of the cutter head 8/10 of mm below the table edge side to side within max .06 mm then set the knives cutting circle .03 mm above table edge. Mac,,

.031” above the body of the cutterhead, the range called for in the setup guide is .026” - .038”, and getting it precise to a mark is difficult because of how everything adjusts - two bolts

Wouldn’t it be too low in this case if I have to set the tables to near the lower end of their travel to achieve proper distance between cutterhead and tables? Certainly possible, though I’m

.031" above the body of the cutterhead, or the height of the blades? How. Did you adjust the outfeed table? If you didn’t keep it level as you adjusted it, then tipping the plane of the table could

I’m talking whole cutter head not table to head martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

Maybe the cutterhead assembly is too high??? Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

Hi Nathan, I sent you a private msg. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Nathan - My 2018 C3-31 also has the buzzing sound when the saw blade stops. Chris Chris Rozycki

Hi Nathan - My 2018-build C3-31 has the buzzing sound on the table saw blade as well.????? -Rich M.

Hi all, I used to own a 2012 model hammer c31 combo unit and I remember the electric motor of the table saw used to applying an electronic break buzzing sound to slow the blade to a complete stop, as

So I’ve gotten the outfeed leveled and set .031” above the cutterhead. The problem when I do that is the infeed loses the majority of its travel and now has a height adjustment of only 0 - .09”.

Btw, if successful in identifying and procuring said adjustable groover for circular saws, a Forrest dado stack will be available…. 8” Mike

Primarily for cutting grooves (dados) in solid stock for furniture work. My spouse is looking for an anniversary present for me. The Forrest stack is ok, but the adjustability of the width of the

Mike, Can you comment a bit on your budget for the groover and your intended application? That would help narrow the alternatives. David Best DBestWorkshop@...

Thanks everyone. I have a Forrest dado stack; what I want is an adjustable groover for the saw. Any options other than Felder? Mike

I second the ridge carbide set, very good quality cut with no tear out on cross-cuts in prefinished maple

I have a ridge carbide dado set it can be stamped for a Felder unit. Very nice flat bottom. [email protected]> wrote:

I have a CMT dado stack purchased from Scott&Sargent. After I bought it a felder dado set came up for sale, which I bought. Anyhow, I have it for sale on FB. Log into Facebook facebook.com Imran Malik

I'll second the forrest dado as a good option, though I only run it on the saw arbor, not the shaper. There is quite a long wait for forrest stuff right now - up to 2 - 3 months according to their web

I bought a Forrest Dado King for my saw. It is a conventional dado stack, but drilled for the Felder. It seems there was some lead time involved, but I do not remember how long it took. It seems to