Imran Malik
On May 19, 2023, at 6:28 PM, habacomike via groups.io <habacomike@...> wrote:
?Bummer. ?The dado has been sold. ?Felder is claiming 6-8 weeks for delivery. ?Any other sources other than Felder?
On May 19, 2023, at 2:54 PM, David Luckensmeyer <dhluckens@...> wrote:Hi Steve:
Theoretically there¡¯s no problem mounting the dado on your shaper spindle. There are no downsides in terms of safety or cutting quality. Just run the shaper on a lower speed. In practice, it will depend on the capacity of your particular shaper. Does your shaper hood accept 228mm diameter cutter heads? And does your below table space allow a 228mm cutter head to lower ¡°enough¡±? It is not just the table opening diameter of your shaper, but also any other protrusions that might stop you lowering (or tilting) such a big cutter. Hope this is helpful.?
Warm regards,Lucky
Dr David Luckensmeyer
From: [email protected] <[email protected]> on behalf of Steven B <sb@...>
Sent: Saturday, May 20, 2023 2:29:08 AM
To: [email protected] <[email protected]>
Subject: Re: [FOG] Felder Silent Power Dado 6.3-20mm #forsale?Not to hijack this thread, but I pose a question for the group:
I'm still familiarizing myself with shaper cutters and operation...Would this dado set be compatible with a 30mm spindle shaper for grooving? And if so are there any downsides to using such large diameter tooling, versus something more standard such as 160mm diameter?
Thank you,
Steve