Re: A3-31 setup and calibration
|
Brian I was trained to set the height of the cutter head 8/10 of mm below the table edge side to side within max .06 mm then set the knives cutting circle .03 mm above table edge. Mac,, Designing and building for 50 years
toggle quoted message
Show quoted text
On May 20, 2023, at 9:01 AM, Richard <rirving@...> wrote:
?.031¡± above the body of the cutterhead, the range called for in the setup guide is .026¡± - .038¡±, and getting it precise to a mark is difficult because of how everything adjusts - two bolts front side, two m6 studs on the hinge side.?
I am wondering if I did mess up level of the outfeed and didn¡¯t realize it when making my adjustments. Will check this am.?
|
