Re: A3-31 setup and calibration
|
Maybe the cutterhead assembly is too high??? Mac,, Designing and building for 50 years
toggle quoted message
Show quoted text
On May 19, 2023, at 11:12 PM, Richard <rirving@...> wrote:
?So I¡¯ve gotten the outfeed leveled and set .031¡± above the cutterhead. The problem when I do that is the infeed loses the majority of its travel and now has a height adjustment of only 0 - .09¡±. Beyond that the height adjustment bottoms out at the end of its travel. I¡¯m sure there¡¯s something I screwed up adjusting the outfeed but I haven¡¯t figured it out yet.?
|
