开云体育

Hi Marty, Glad it worked for you. Do you recall what your display shows upon power up? Imran

Sorry it took me so long to respond.? I followed Ameer's directions because his display looked the same as mine.? Everything worked fine except the reset button doesn't always "reset".? It's a bit

Mike, Please share the wiring diagram. Without that here is a generic response. If your machine is single phase check the start caps. Make sure all safety limit switches are inactive. Either way, 1P

Here is a link to an Abilene, TX Craigslist with several large woodworking/metalworking machines including two large bandsaws. Other than posting this Craigslist link I have no knowledge about any of

ahh man! I was hoping to buy it for a dime.. thanks a lot!! LOL

Many thanks to David, Imran, Brandon any everyone else who responded. Apologies for the late reply, but I put my back out while I was unloading everything? (ironically, reaching for a small piece of

Thanks for the replies, it took a pair of pliers to break the knurled screw free, all is good now

I just received my Quick Lock shaper cap (thank you again Michael Marsico!), the instructions that ship with it explicitly say to NOT touch or loosen the slotted set/grub screw. You should be able to

Great info Andrea questions. Can’t wait to get over there and look at the unit to see what accessories are there. Will definitely send more info when I have it. Can’t thank you all enough for the

“Going out on a limb” because I don’t know for sure… Regards, Mark https://www.instagram.com/kessler_woodworks/

Going out on a limb here to say no, i though you just loosen the hex Regards, Mark https://www.instagram.com/kessler_woodworks/

Does anyone have the Felder Quick Lock. I ordered it with my new saw but I can’t get it to loosen, does the red screw need to be removed, I tried to loosen it but it won’t budge.

Hi all. Probably simple fo someone who knows more than I do: Over the years, occasionally I’d turn off the saw with the small red button (not the emergency twist knob ) and then the saw wouldn’t

Tom, If you are interested in Festool power station, I would definitely check operational temp requirement. Battery performance drops in cold temps and you have plenty of that in Minnesota. The

Tom, Have you considered a 240 volt portable battery set up? Like this only 240 volts? https://www.youtube.com/watch?v=8b015OS6LXs <https://www.youtube.com/watch?v=8b015OS6LXs>

This is great info, thank you gentlemen! As Mark Thomas points out, yeah this is a bespoke (made in-house by Mafell) "universal" motor, so there's no re-winding or modifying it. Imran, yeah the

Ameer, My first step would be to check with Felder if U 2.1 is normal or an error code. I do not know if the machine even displays error codes. Could be software version, who knows? If you call Felder

Festool battery is 1555Whr. So only good for little over 1 hr runtime for the 1300W saw even less for 2500W model. Maybe that is enough for intermittent use. I think besides checking with OEM options

Please check emergency stops and all limit switches as your first step. Imran

I am measuring after the breaker. Swapping lines out of the breaker does not change the measurement so the issue is before the breaker. When I first measured currents Leg “B” was low. It was low