开云体育

Did want to mention that the OP did do a nice clean installation though. Other comment would be that I would want it on top of the fence body, a lot of times i am adjusting the rip from the other

Is anyone remember trying to make accurate cuts using a laser? Great for rough oversize cuts but dead nuts on the line? Regards, Mark https://www.instagram.com/kessler_woodworks/

Mark Kessler, I had the same thoughts on the Wixy.? I had one that I mounted on a Biesemeyer fence. I would say it's not a professional product. It never really worked that well for me. But I'm

This really doesn't work at all. The lines lack focus and vary in width as well as not being visible enough. Would very interested to find a solution that did work though and is available in the

Thanks Mark

thanks Cindy. i will check if my red one is 8mm. in that case i can just swap red with green. i will be using it in few days after couple of yrs. will see if it is adequate. imran

I'd rather cut to a scribed line? A laser has always seemed a little fuzzy? to me.

The Wixey has a magnet on the side for attaching to the fence head. Easy to move out of the way when tilting the head. [email protected]> wrote:

Imran's questions: (My answers are in Times New Roman) did you buy this model? YES https://infiniter.com/vlm-520-28-lpt-economical-direct-green-line-laser-module-wavelength-520-nm/ how wide is the

Here's a picture of the arms and you can see how it "curves and is not flat..

Thank you kindly.. Jason..I did quite a few things differently on the 2nd chair.? the first chair with the thinner arms, leans back more.? I purposely moved the upper legs forward more so the chair

Mark, sometimes i ask the question just to have an answer documented here. i am not sure what my plan is. too many more compelling things ahead of adding DRO to the rip fence ? Imran

I don’t know how the wixy works but the accurate technology reader i had was “keyed” to the encoder rail so you would have to disconnect a cable from he head to do that, doable but for me a

Mark, That is the reason I asked the question of how it is attached to the fence housing. If it is done with a magnet then one could separate for flipping the fence, which I also do often enough.

Hi Randy, Really nice work! Can you post the two of them together from the same angle? Besides the difference of the accent woods, the main change I see is in the arms. I personally find them to be a

Wixey is not a “mag” strip dro, it uses an encoder rail which means the dro head and/or reader and rail are “connected” which means if you want to flip the fence out of the way you can’t

mkornell, Thanks for sharing. how is the wixey display attached to the fence housing? imran

Randy, the chairs are stunning, thank you for the inspiration, well done ! Cheers Peter Cape Town

Newish Felder owner, first time posting... I bought a K700P this summer and added a Wixey DRO to the rip fence. The Wixey head and mag strip don't fit the extrusion on the front edge of the table, so

Hi Cindy, did you buy this model? https://infiniter.com/vlm-520-28-lpt-economical-direct-green-line-laser-module-wavelength-520-nm/ how wide is the line with your setup? are you able to easily see