开云体育

Hi Brett, That is fair. I just asked because I have done both and I find sled efficient and easier. However, I am far from being an expert on anything. I am in awe of you and others who routinely

Imran, I've not used the SLR sled in the earlier reference mostly because I don't like taking time to make jigs if I can just get the job done some other way. I'm not in a position to argue it's

Jason, I use electric radiant heat panels for heating my shop. While pretty efficient it still costs money. I am not generating any income from WW. I have kept it at 50F in past and would stay warm

Brett, Have you used a sled for SLR? I would do may be 3 to 5 boards with track saw but sled comes out for higher qty. No contest for over 100 boards Glen is looking at. Getting them S1S is definitely

Imaran, How is shop temperature 50? That's barely warm enough for Titebond, and definitely not warm enough for my hands. Jason Holtz J. Holtz Furniture www.jholtz.com 3307 Snelling Ave. South

a basic 22n will do all 4 in one pass martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

Hi Glen Why not just joint them than batch a bunch together and plane to width or let the moulder do it. We I assume are just talking 16’ 1” and less than 25# a price even if 2” not so much so

Glen, You might check what a local lumberyard would charge to straight line rip. My vendor in Oklahoma City charges $0.08 a board foot to straight line. It's hard to beat that price. Jarrett

Glen, Are you getting S1S? I buy my quantity lumber at minimum 1-side straightlined and hit-and-miss planed. Plus I find I can stack it easier and the price is insignificant compared to the confidence

Which shaper is that? Is that the side tenoning table I see? Thanks, Dave Davies wrote: -- Dave & Marie Davies www.myfinishingtouch.com 318-219-7868

I ordered a spindle moulder from SCM last July. and it finally arrived yesterday. Just happy it got here given the hard times Italy were exposed to the pandemic.

Awesome. Congratulations. Memories too. I remember building descending platforms (vs ramps) to use rented pallet jack to get my kf700 from pallet to garage floor.

Glen, The video Jonathan shared shows how to make one. I would add few observations from my use of one. First I made mine with thin ply on each side of 1/2” spacers. Being 12’ long I added 4’

Thank you all. Just getting the rest of the shop cleaned up and set, and tomorrow i should be turning it on. It was a beast to move and yeah, a very long ramp! But i was determined to go slow and be

David, Since the main drive belt did not show signs of deterioration I left it alone. I did noticed that the belt had a tiny but of flutter. Not sure about hearing a pure tone though. I figured it has

SLR saw for sure. Doesn't your buddy have one? Most people who have a moulder do. Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN 55406 612.432.2765

On Mar 23, 2021 05:32, Glen Christensen <grchris1966@...> wrote: In my great ability to take on jobs that are over my head, I got a new one today. ROTFLOL So i need to straight line material

Thanks again Brian for all your help. ?Amazing customer service!

Imran, good summary. How did you tension the main drive belt? My Dual 51 motor shaft snapped off because the early machines from the factory had belt tensions set way too high. After replacing the

Good summary Lucky. I will only add that if you take a deep enough cut to eliminate cup and twist coming onto the outfeed table, the high feeder pressure doesn’t matter - there is nothing to flatten