开云体育

Very Funny. Did you edit that?

Imran:

Hey, something up there still works ? Imran

493 pounds. 500 is close enough ;-) [email protected]> wrote:

I am going to place my bandsaw on skids. I can look it up but it likely weighs ~500# - Laguna LT16SEC. Any reason I should not use SPF lumber for this? BTW, this stuff is couple of yrs old if not

Nice! Here’s my version of a mobile base for the AD741. In a small garage and need more freedom in moving it.

Keith, Thanks for the update. Great news. As we hypothesized the racket likely came from chain drive for the feed rollers. Happy woodworking. Imran

I could see the angled cutter head working great on chip out prone material, I’ve skewed boards across my jointer all the time. The the idea that the angled head solves the twist in the board

Dave that makes good sense. Woodmizer tension there saw I’d say average of 3 to 5 thousand pounds. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

Hi Imran Installed new capacitors and everything works fin and quiet, thanks for the help . Keith ________________________________ Sent: March 14, 2021 8:01 PM To: [email protected]

Congrats Andrew!? Looks like you may not need a workbench...you can use the beast of a pallette that machine came on !;).

If the machine works on twisted board, either I am too thick or the video is not able to show the concept. The board is flattened by the overhead bars before the board gets to the cutterhead. How does

I just sent for amusement value, not an endorsement. The video is kind of nonsense of course, but it’s an interesting question if the angled cutter head has value.

it is the TI145 with side sliding table, I ordered with the following spec Overhead touch screen Electrospindle Side sliding table Pro-TL version (there are two types of side sliding table, I ordered

I don’t buy that video for a second… it squishes the board flat and doesn’t take into account the twist in the board. Brian Lamb blamb11@... www.lambtoolworks.com

Or just get a nice jointer with an angled cutterhead: https://www.youtube.com/watch?v=g_hd8nGul9Q

Hmm, never thought about that Sent: Tuesday, March 23, 2021 10:36 AM To: [email protected] Subject: Re: [FOG] PF Wheel Durometer for Shaper and Jointer? You run the board diagonally… I do

Brian, Thanks. I will have to try that ? Imran

Yes, if the board is twisted, I run it through with the power feeder running diagonally over the two lower corners, that way it takes half the warp off each end. Brian Lamb blamb11@...

Brian, Is that (running diagonally) for twisted boards? Diagonally, as in with respect to cutterhead? On a twisted board, I just find a spot where I can push down and the board stays in a good spot. I