开云体育

All of Mac's stuff looks like that. Mac, I have a surface grinder so if you need steel made flat, I'm your guy. Boring repetitive work is my specialty. Dave ________________________________ Sent:

Eric, never thought of running material thru WBS to remove dust. should only take a light pass. i like tersa on mine for quick change. i am sure those pesky little hard to rotate guys do shine in

Imran, I am in your camp - joint near, plane far on my Dual 51 -- 368 of those suckers - errr, cutters - so replacing them is not only a bit of $ it is also time. As others have mentioned, what you

Mark, interesting that your come off as it is essentially same size as mine. seems like, you may have seen the pic i sent you where i showed the slight slot i made in the slider handle. the nut you

Imran, duno, I have flat steel bar for my clamps and have no issues they are99mm x 31.76 x 12.5 (btw, they can come off the xroll with clamp attached with no modification the the handle on the xroll)

Mark, i guess i can see benefit in softer material however, that is due to material not due to application. Felder provides T-Nuts for the secured nut for the short xcut fence. these are secured by

Imran, I can think of a few benefits of a t-nut over non T, one would be additional pull out strength due more threads in a softer material like an aluminum or even steel if the application calls for

Nice nuts - Mac... Regards, Mark https://www.instagram.com/kessler_woodworks/

Mac, one i have from felder for KF700 xcut fence (one that floats in slot, not the fixed one) is flat and not t-nut. it measured 30x10mm i did not measure the length. no chamfers. BTW, what is the

Beautiful Mark Foster

Martin on right Felder on left Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

I have made over1000 nuts but never made one 1.25 in width all Felder are 30 mm shouldered at around 20 mm for t slot table width. 303 stainless steel 10 mm x 1.5 thread ,, beveled on 22 edges than

i got a question on tolerance for the nut. i had not looked this up before but i found general info for CR1018 in the size i plan to use and tolerance is +0/-0.004. i will verify with supplier on

Murray, For hobbyists like us it is always better to ask the experts, but honestly, you are almost over thinking this. Joint it, resaw if required, plane it, buy a straight forward T&G cutter set, try

Michael, Could you provide more details on the build of the finger joint jig? Thanks, Dave

I use talc powder like the baseball players use on there bats, I don’t put my hands over the cutter head. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106

Nice tool boxes it is some interesting wood. Not common in the Midwest, mine was FREE Salvaged from Deck. I made a number of Isheco drums , tapered cylinders. With it . martin/campshure/co/llc mac

Cliff, i assume you are joking to get some free timber. but if not, i started the thread to share a free downloadable wood handbook put out by USDA. if interested, go to the first post for a link.

jonathan, good point on adjustable groover option. i now have two sets to cover range from 4-20ish mm but have not used them for T&G. on paddles, i had orange ones that i gave away with my jointer. i

is the timber species Jarrah? the excellent free resource mentioned in the subject line?