All of Mac's stuff looks like that.
Mac, I have a surface grinder so if you need steel made flat, I'm your guy.? Boring repetitive work is my specialty.? Dave
toggle quoted message
Show quoted text
Martin on right Felder on left
Mac,,,
Designing and building for 50 years
On Nov 28, 2020, at 6:10 PM, Airtight: Clamps by Air Compression via groups.io <airtightclamps@...> wrote:
?I have made over1000 nuts but never made one 1.25 in width all Felder are 30 mm shouldered at around 20 mm for t slot table width. 303 stainless steel?
10 mm x 1.5 thread ,, beveled on 22 edges than cleaned and polished 100 mm in length usually .
Mac,,
Designing and building for 50 years
On Nov 28, 2020, at 5:07 PM, imranindiana via groups.io <imranindiana@...> wrote:
?
i got a question on tolerance for the nut. i had not looked this up before but i found general info for CR1018 in the size i plan to use and tolerance is +0/-0.004. i will verify with supplier on monday and share
if it is different.
i also measured the one nut that i built earlier this yr. it meets the tolerance given above. this is a ~4¡± long nut.
above is xroll. the bottom edges will be chamfered for pre-xroll.
imran?
On Nov 26, 2020, at 9:29 PM, imranindiana via groups.io <imranindiana@...> wrote:
?
Cliff,
after posting i realized that i should have added some details. figured, i will wait to see if there is any interest to start with. but since you brought it up, here it goes:
made out of CR1018 0.5¡± x 1.25¡± flat bar stock. you need to let me know if your machine is xroll or pre-xroll. i cannot guarantee compatibility with non-felder machines.
nut length is 2¡± but you can specify any length at $1/in for nuts over 2¡± in length. if shipping is affected i will let you know.
one tapped hole of your choice in the middle of the nut from std offerings up to M8 or 5/16¡± and associated coarse thread.
i will entertain your need outside what i have listed above as long as i have the tap, just let me know what you need.
imran
On Nov 26, 2020, at 7:50 PM, Cliff Rohrabacher, Esq. <rohrabacher@...> wrote:
?tell whether they can select their preference for the thread in the
tapped hole. ?mm ?imperial, ?& what size, that sort of thing
On 11/26/20 12:17 PM, imranindiana via groups.io wrote:
well i need to make a few for myself and thought i check if anyone is interested. this is basic cold rolled steel 1018. pre xroll slider need two edges chamfered. i am thinking 1 for $25, 2 for $40 and 3 for $50 shipped to lower
48.
please select reply to sender below if you are interested.
imran
