On Nov 28, 2020, at 5:07 PM, imranindiana via groups.io <imranindiana@...> wrote:

?

i got a question on tolerance for the nut. i had not looked this up before but i found general info for CR1018 in the size i plan to use and tolerance is +0/-0.004. i will verify with supplier on monday and share if it is different.

i also measured the one nut that i built earlier this yr. it meets the tolerance given above. this is a ~4” long nut.

<image0.jpeg>

<image1.jpeg>

<image2.jpeg>

<image3.jpeg>

above is xroll. the bottom edges will be chamfered for pre-xroll.

imran?

On Nov 26, 2020, at 9:29 PM, imranindiana via groups.io <imranindiana@...> wrote:

?Cliff,

after posting i realized that i should have added some details. figured, i will wait to see if there is any interest to start with. but since you brought it up, here it goes:

made out of CR1018 0.5” x 1.25” flat bar stock. you need to let me know if your machine is xroll or pre-xroll. i cannot guarantee compatibility with non-felder machines.

nut length is 2” but you can specify any length at $1/in for nuts over 2” in length. if shipping is affected i will let you know.

one tapped hole of your choice in the middle of the nut from std offerings up to M8 or 5/16” and associated coarse thread.

i will entertain your need outside what i have listed above as long as i have the tap, just let me know what you need.

imran

On Nov 26, 2020, at 7:50 PM, Cliff Rohrabacher, Esq. <rohrabacher@...> wrote:

?tell whether they can select their preference for the thread in the
tapped hole. ?mm ?imperial, ?& what size, that sort of thing

On 11/26/20 12:17 PM, imranindiana via groups.io wrote:

well i need to make a few for myself and thought i check if anyone is interested. this is basic cold rolled steel 1018. pre xroll slider need two edges chamfered. i am thinking 1 for $25, 2 for $40 and 3 for $50 shipped to lower 48.

please select reply to sender below if you are interested.

imran