开云体育

I really use the term “bean counting” to refer to “value engineering”, as I suspect most people do. Obviously the accountants aren’t the ones making these decisions, it’s marketing and

DoAll is a fine example of early sheet metal manufactured saw. Very well built I have an 18”. I am not to sure filling column with concrete will eliminate vibration. I have a 36” Oliver and have

Companies use cheap motors and the buyers blame the bean counters. Dave- bean counting right now. ABB makes high and low end motors. ________________________________ Sent: Saturday, February 22, 2020

fwiw, my FB610 is not terrible vibration-wise, but certainly nowhere near as smooth as good old iron or my old DoAll metal saw.? I've never run newer saws like ACM, so can't compare to that.? So I

The only thing that is the same as oliver original is the name they bought for $100,000.00 That’s it!!!! martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

If I had the dimensions, I could model that with a longer, smoother transition for you guys. My printer is packed away as we are remodeling our house at the moment, but I could post the stl file no

I don’t see anything wrong with the machine. The OP used possibly the worst possible combination to test, tall relatively narrow and putting them way off center. Try a 3 foot long piece of 1x6 run

Sorry, I guess I wasn't clear.? I wasn't intending to show a mis-adjusted roller.? The point is that the roller is pushed down on either end by a spring.? At rest, the roller is lower than the

So I just watched the vid and it is a bit much but does it really matter? I have had it happen and I just push on it to straighten it out if I feel like it’s necessary for some reason. Does the

Mark, similar but your illustration showed the affect of roller not being parallel to the table but what I am suggesting is possible with roller that is parallel and is much more likely to occur if

Sadly I won’t be able to produce them but with the .stl file you probably could find someone online to make it for you. Regards, Mark

The only time I get snipe is when I forget to lock the table.? If it? is unlocked the table can wiggle. There's not a lot to do in setting the planer up. I have broken my entire machine down? once

Weird, seems all the pics are not posting? Trying again

that's awesome!! I'd buy one..

As illustrated in my drawing, it’s impossible for the rollers to contact all at once when the board is at far edge. The roller is applying more pressure on the inner edge of the board, then the

The additional pics, also btw it was a 24hr print and about $37 in material... Regards, Mark

Some additional pics and a vid... Regards, Mark

I 3d printed a fitting for the overhead guard with a 4” port, I will add the .stl to the files section Monday as I forgot to bring it home with me today. It’s not perfect as my modeling skills are

? ? These pieces are tall compared to width and length. If the infeed roller does not contact the entire leading edge at once it can easily pivot the material. Unless I was using this type of

David, I love that old iron. I live out on the edge of civilization so I don't have ready access. Short story. In about 2004 I bought a used, cheap Chiuting thickness planer. It produced smooth, flat,