开云体育

Good going , figure that system out you deserve a prize!! Moving barrel 6 in and out adjust top and bottom changes the angle of the assembly to move table up and down . I poor design at best. Cutter

Here's the crown on recent vintage FB610, about .015"

Ok, So I blew one of 5x20 1a slow blow fuses. Just ordered some on amazon and they'll be here tomorrow. called felder tech support with the electrician here and they got the wiring all sorted out.

Rough and or wet, i had them on my big SCM and only remember using them at high speed feed rate and just to skip dress Regards, Mark

We just went through this whole topic a few days ago, you will find the answers in previous posts. -- John Kee JMK Servic

You must have different wheels then what I've seen on a lot of Felder bandsaws. All were completely flat. Properly setup with proper tracking and blade tension results in no drift unless the blade is

I follow Snodgrass's method on my 610. I tried the front of the wheel thing and it wouldn't cut straight. Using Alex's method it cuts straight. I find it easier to adjust the tracking than adjust for

Think those are the correct ones but you could always give Felder a quick call and confirm that they are the correct ones.

The only time I thought bed rollers were worth the effort was when they were powered. Few are now so I'd save the 750 unless you run really rough stock. Dave ________________________________ Sent:

Frost King V23WA Ribbed Rubber Self-Stick Weatherseal Tape, 3/8" W, 1/8" T, 17 ft L, White https://www.amazon.com/dp/B000OZT84K/ref=cm_sw_r_cp_apa_i_ougtEbJ87DGHB This works great for 5 and 6 inch

Integrated adjustable rollers for AD 951 is a feature offered for the Felder 951. Anyone have experience with using this machine with and without this feature? It's an upcharge of $750. I have always

Definitely not as easy to reconfigure the spiral compared to clamp together especially if you need to change something in the middle of a run, not sure if it’s worth 4-5 times the cost of spiral

I own a Felder FB 510 and have run my tyres centrally - without realising the profile is close to flat rather than crowned as some posters have pointed out. But I have experienced no issues. My

I really like the Nordfab ducts.? I reconfigure it for new machines and took less than an hour.? I don't think you can do it as easily with spiral ducts when I was researching the two options.?

Not mine but figured I’d share in case this is of interest to someone here. https://reading.craigslist.org/tls/d/pottstown-biesemeyer-square-tablesaw/7077892823.html Ron Magliocco 1-203-216-4629

I have used both, and I have also used Sharkguard by Lee Valley. my opinion and experience is that overhead guard are more superior than the standard type. there are times a standard one may work

I was curious about the recommendation here is.? I recently saw a video by Alex Snodgrass where he recommends positioning the blade gullet at the center of the wheels as it gets the most support

All I currently have this Felder dado set ( http://us.feldershop.com/en-US/en-US/en-US/Sawing/Tongue-and-groove-cutters/Adjustable-Dado-Cutter-for-Saw-Unit-RB-HW.html ) , but misplaced the shims

Timely post as i will be asking some questions about norfab vs spiral. Why not just buy replacement nordfab o rings? Maybe mentioned and I missed it Regards, Mark

I've replaced some of mine with the white roll sticky backed seal material that you can get at home depot or Lowe's. I'll try to look up the specific details later. Marlowe McGraw