The only time I get snipe is when I forget to lock the table.? If
it? is unlocked the table can wiggle.
There's not a lot to do in setting the planer up.
I have broken my entire machine down? once when I was swapping
out the? cutter block for? shellix?? re assembling it was pretty
straightforward.
I am little?? confused at the? reference to feeler gauges.? What
are you doing with? feeler gauges?
I use a standard machinist's test indicator in a movable stand? I
set the jointer tables to be co planar and the? outfeed to be dead
even with the? TDC of the cutter.
No tapers no snipe? no issues.
On 2/20/20 4:16 PM, Will Smithee via
Groups.Io wrote:
toggle quoted message
Show quoted text
I ordered my C3 31 on 12/29/2019; received it on 1/24/2020.? I've
been trying my level best to set it up and have not been able to
get the planer to stop kicking and/or sniping boards.? I've worked
with tech support and now a field tech has been working with me as
well over the phone and email.? I've been using very accurate
gauges (0.01 mm) and have sent photos and videos to the Felder
staff multiple times over the last few weeks without any success.?
I am at my wits' end with this machine.? I've filled a large dust
collector bag already with just the chips from attempting to
adjust this planer.? I'm about ready to tell Felder they can take
the machine back and I'll go with another brand.? I've setup other
machines previously and never had anywhere near this much trouble
and never had to spend more than 6 hours adjusting even much less
expensive and/or sometimes poorly built machines (Harbor Freight,
Grizzly, Dewalt, Steel City, Delta, etc.)
Has anyone else had problems like this or struggled this much to
get a new machine to work properly?
