开云体育

I don’t see anything wrong with the machine. The OP used possibly the worst possible combination to test, tall relatively narrow and putting them way off center. Try a 3 foot long piece of 1x6 run

Sorry, I guess I wasn't clear.? I wasn't intending to show a mis-adjusted roller.? The point is that the roller is pushed down on either end by a spring.? At rest, the roller is lower than the

So I just watched the vid and it is a bit much but does it really matter? I have had it happen and I just push on it to straighten it out if I feel like it’s necessary for some reason. Does the

Mark, similar but your illustration showed the affect of roller not being parallel to the table but what I am suggesting is possible with roller that is parallel and is much more likely to occur if

Sadly I won’t be able to produce them but with the .stl file you probably could find someone online to make it for you. Regards, Mark

The only time I get snipe is when I forget to lock the table.? If it? is unlocked the table can wiggle. There's not a lot to do in setting the planer up. I have broken my entire machine down? once

Weird, seems all the pics are not posting? Trying again

that's awesome!! I'd buy one..

As illustrated in my drawing, it’s impossible for the rollers to contact all at once when the board is at far edge. The roller is applying more pressure on the inner edge of the board, then the

The additional pics, also btw it was a 24hr print and about $37 in material... Regards, Mark

Some additional pics and a vid... Regards, Mark

I 3d printed a fitting for the overhead guard with a 4” port, I will add the .stl to the files section Monday as I forgot to bring it home with me today. It’s not perfect as my modeling skills are

? ? These pieces are tall compared to width and length. If the infeed roller does not contact the entire leading edge at once it can easily pivot the material. Unless I was using this type of

David, I love that old iron. I live out on the edge of civilization so I don't have ready access. Short story. In about 2004 I bought a used, cheap Chiuting thickness planer. It produced smooth, flat,

Your C3 31 is similar to my MinMax CU300 in that the planer table is supported by a single column.? It's hard to tell by looking at the pics, but it looks like there are 4 bolts at the bottom of the

From the video it appears the board kicks when it contacts the infeed or the cutterhead. I could not tell if it is kicking before wood contacts cutter head. So the board appears to have moved before

SW, Thanks for the follow up. It's good info. To isolate the vibration source, did you try running the saw without the blade as you did before? Jon S Sent: Friday, February 21, 2020 4:21 PM To:

Ok 220# to 900# martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell 608-824-0023 fax airtightclamps@... airtightclamps.com Designing and building

Not really fair to compare a 14” tool with a 28” tool one probably weight 30 to 50# and the other 1200# . There is a lot mor going on. How are the quality of cuts? Mac,,, martin/campshure/co/llc

I know from my own experience that those poly V belts that Felder uses can take an exceptional amount of tension to resolve noise and vibration issues. Absolutely no deflection at all.?JohnJMK