开云体育

-- Justin 2000 EVW 1.9TDI Syncro 5-spd 490k mi :-)

2002 EuroVan Winnebago camper,? 180,000 miles My local mechanic has spent 5 hours trying to trace why the speedometer quit and the cruise control quit. They quit about the same time.All of the

No, they just hold the front and rear halves of the bolster together. -- Duane 05HD Rialta 220K Miles

Thanks Duane & Phil. I'm doing my back stretching exercise in order to get back in there. So the 13mm NUTS I took off the bottom of the bolster didn't have to be removed? Guess I'll find out.

Spencer As always, Duane’s photos and info are a true great resource and hidden key - the third bolt (right back inside) takes serious contortions to get to keeping in mind it goes into the bolster

That's all it takes.? I originally made that file.? The 'secret' is to remove the cover on the end to see 2 of the bolts.? The 3rd is under the bolster on the back side. -- Duane 05HD Rialta 220K

Thanks Duane. Those are two good files that cover the switch replacement. At the bolster removal one just says to remove it with no info on how and the other says to remove some 13mm bolts. I'm trying

There's a file that shows how to do that here on the group, /g/eurovanupdate/files/IgnitionSwitch.pdf It's only for the electrical part of the switch, not the

Got to replace the wonky ignition switch and am now at the bolster removal. So far got the cowls removed and also the side panel- after punching out pins. I've removed the nuts along the bolsters

Thanks all, will be ordering the wrench from Baumtools.

On Sun, Oct 9, 2022 at 03:11 AM, Duane wrote: > > AES/AXK engines

Thanks David. I've checked that and it seems fine. Cheers, Steve

On the AES/AXK engines, it's an M8 all thread bolt and needs to be at least 2 inches long.? I bought a bag of M8x75mm at Fastenal years ago and give them away as needed.? I originally bought 40mm

A couple months back when I replaced the belts on my 1995 EVC, I used a prybar to release the tension on the top pulley to remove the serpentine belt. This is write up on TheSamba.com I posted on that

The flexible duct sometimes comes loose, as well. -- David 1705.net 95 EVG(lamper) Seattle, WA

If you have a 95, this tool will do it. https://www.baumtools.com/shop/vw-audi-specialty-tools/vw-audi-engine-crankcase/3299-ribbed-belt-installer/ -- David 1705.net 95 EVG(lamper) Seattle, WA

George It would be helpful if we knew what Eurovan, year, model you have. To get slack in the serpentine belt, you have to screw in a M8x1.25 inch (can be longer) bolt into the tensioner. That's for

Have to change my AC Compressor, where can I find a wrench to take the tension of the belt?

Thanks Mark. I did wonder about this option. I might see if I can have a look. I'm guessing to access the furnace you need to remove a lot of plastic panels. Steve

Just a guess, here, but you could have a blockage that's causing the hot air to back up to and out of the exterior vent. This has been known to happen when a small, furry critter builds a nest in the