开云体育

Okay, I think I get it now. I have to remove that plastic interior panel to get access to the nut so I can hold it while removing the bolt. Is it similar on the left

The "fender panel"? You mean the interior plastic panel? To remove the interior panel... all the screws around the edge, I presume? Thx, Serge snet.net@groups.io> wrote:

Cv joint? Wheel balance? Does it change under braking or cornering? Cheers, JM gmail.com@groups.io> wrote:

Okay - sorry for not reading your full email - yes you will need to remove the lower wheel arch interior panel - that will give you access to reach the nut. Apologies for skipping that step - I did

Theirs is a nut on the backside that you must find a way to grab hold of. I think I used a smallish crescent wrench to do it. Be VERY careful not to let the nut drop down as you might never see it

The steering wheel of our van vibrates noticeably at low speeds-20 mph or so. Any thoughts? Happy holidays and thank you! Bailey 2000EVC

Yes,unfortunately you need to remove the fender panel. There is a nut on the back. Sent from AT&T Yahoo Mail for iPad

I keep turning this bolt (right rear bottom) and nothing… How do you remove this? Take the panel off? Ugh. Thx, Serge

I don't know about the exhaust manifold, however I'd give Josh a call at Mike's Foreign Car, Inc. 2818 E. Miraloma Ave Anaheim, CA 92806 (714) 630-7113 Working Hours Mon - Thu: 7:00 AM - 5:00 PM |

I don’t know if they do exhaust work, but Escondido German Auto in Escondido we’re willing to work on and quite knowledgeable with my 95 EVC. Escondido German Auto 1554 E Grand Ave, Escondido,

Can’t confirm exhaust manifold work but these shops are my go to’s. Rony's Car Pros 4232 Sepulveda Blvd Culver City CA 90232 ?(310) 559-6463? Vera Golf Auto Repair 808 West Pacific Coast

Does anybody know of a repair shop in Southern California that has done or is confirmed willing to do exhaust manifold work on a 1993 EV? I've taken my EV to two shops, and neither of them want to

Thanks.

I ended up calling my regular EVC shop, G Imports, and talked to Graham (the owner). He says he can do the install and alignment at his shop, and even connected me to a tire shop nearby. I’m in

I did the same! Let me know if you find an installer. I’m in Marina del Rey. Scott Smith

Hi Friends, Just ordered the GoWesty kit to finally! replace my aging 15” steelies and get some better rubber options. And level out the terrible lean! Any alignment/suspension shops you like in

Richard Middleton at Cool Air Auto in Belton, Missouri rebuilt my Eurovan automatic transmission. Certainly one of the top VW auto trans builders in the country. Kansas City TDI | | | | | |

Raul’s German Auto in Santa Rosa, CA - there are other local German auto repair shops in the area but I haven’t used them or know if they work on EVs. Raul is great and very reasonable. Kate 03

There is a database ( /g/eurovanupdate/table?id=18565 ) of repair services, most of it imported from the Yahoo Group, so it's sadly out of date.? Only the last entry has been made

Sounds good Ken thx. -- Justin 2000 EVW 1.9TDI Syncro 5-spd 505k mi :-)