开云体育

The thermostats for to turn gas on and off is wall thermostats . ?thermostats in heater controls the fan off and on. ?Turn off at fuse panel will turn it all off.

Have you tried turning off power to the heater at the circuit breaker panel?

Today was the first hot day. I disconnected the thermostat for the heater a few days ago. But that did not fix the problem. The fan for the heater still went on. There must be an additional thermostat

Sometimes the N80 valve fails and causes a hard start condition - extended cranking. You can test the valve by putting 12 volts across the terminals and listen for the distinct audible click like a

Hi all, I'm servicing my EVC before a trip. What is the correct level of transmission oil on the dipstick (I have a dipstick kit on my EVC) when temp is between 86-98 degrees on the Scanguage ? Is it

Yves, the Westfalia version Eurovan camper, 92-94 is often referred to as the Canadian Camper as it was never sold in the US. No doubt you're 97 EVC is a Winnebago version which was sold in both

I ordered a custom mattress from Mattress Insider for our 95 camper, for the top bunk. I got a 74” x 42” @ 4.5” thick. It’s 2” of Gell with 2.5” of memory foam wrapped in an organic cotton

Unfortunately, my Canadian ‘97EVC has only got a 41 inches wide factory bed !!!.....maybe the ’92-’93 models are wider but not mine. I had a mattress factory make a foam top for my camper which

Heads up for Westfalia (Canadian) Camper owners with the factory bed: Your bed is wider than the Winnebago EVC full camper. You should be able to fit a 48" mattress on the Westfalia bed. The 41" one

I agree that getting some kind of code readout will really help. Also the coolant temperature sensors have caused issues: https://europarts-sd.com/sensor-coolanttemperature1999-2003.asp

Like many things Eurovan, this is NLA (no longer available)! But this looks like its replacement (in the medium double size): https://www.rei.com/product/171124/exped-deepsleep-mat-75-duo-sleeping-pad

I use an exped mattress upstairs as well as down without a problem. Very comfortable.

Thanks for this helpful recommendation. One question - do you think that it would be too thick for the upper bunk? Take care, Barry

I was unaware that the weekender is different, sorry for the misdirect.

That REI product would be quite narrow for the Weekender, which has a 60" wide bed below. I can't see how one would thicken the seat cushions on a weekender either.? ? I suspect that Jonathan is

I had similar problems with an AUDI ( same engine) Turned out to be leaking fuel injectors when warm which flooded the engine and soaked the spark plugs. Do you smell a gas odor in the engine

When my 03 Jetta became hard to start, it turned out to be the engine speed sensor. Fairly easy to replace on the 24v vr6 I would also be suspicious of the cam position sensor. The ecu uses it to fire

as recommended by Paula and Michael https://www.rei.com/product/113720/exped-megamat-duo-10-sleeping-pad (get the Medium Double size, which is 41x72 inches.) I had my standard downstairs cushions

Morning, John, There's a myriad of reasons what causes a hard start after an engine is warmed up. I suggest you document the issue well (length of drive, where you go (elevation), time of day, ambient

Anyone have recommendations for the weekender downstairs?