开云体育

I have that BenQ as my lo-res desk monitor at home. Works great and I watch TV on it sometimes. Now that I have my 28" Samsung UHD 4K monitor I mostly put the TV in the corner as a PIP source. It's

Supposedly these are really good. http://www.amazon.com/dp/B00ITORMDC/ref=cm_sw_r_tw_awdm_DRtcub1QGCPHE Chris Crestron@...> wrote:

I have used the traditional Infinet version on my night stands at home for years as well as on many installations. The response time is pretty instant. If I try to dim the lamp from being off while

Hi guys I am not a home integrators we do commercial work. I am working on doing my home completely Crestron and have the CHV-THSTAT controlling my HVAC. I am thinking of adding an outdoor sensor. How

yep seeing the same thing. Are they enforcing the object count in the free version differently now?

I have two 1052 panels both reported dead within a few days of each other. Can't reach either one of them with any tools, and of course they're out on a fairly remote island. Not sure what firmware is

So, what I found with this dumb display is that the discrete IR power on and power off commands for Sharp displays actually *toggle* power. Send it either one, it will toggle its power. So, since

I was actually reading up the help file for this yesterday, both of the USB-EXT?s have to be on the same subnet, this will not go through routers, since its a Layer 2 device only. I would check if

I had a job yesterday where the customer had installed the app update. When I tried to install new graphics to support some additional lighting loads at the house the graphics were stuck on the older

With Mobile Pro v2.0049 everything is fine. With Mobile Pro v2.0053 some buttons have been totally disappeared. Strange.... 2014-09-03 15:40 GMT+03:00 acuervo1@... [Crestron] <

What did you do to make this work? Can you share the command strings? I haven't had any luck communicating with the generic CEC modules.

http://www.bolandcom.com/product/sel27/ or they have two other 27? models :) $$$ :( From: "chris.anello@... [Crestron]" <Crestron@...> Reply-To: <Crestron@...>

Have an opening that needs 27-30" Display, and there are no 1080p TVs out there in this size anymore. We have used Computer monitors before, and with DM where the signal sensing turns the display on

I have a system with a Microsoft ppi board and 2 local pc's. The problem is that I cannot get the Crestron USB-EXT-DM's to pair over the network. I can connect them directly together as an extender,

My test 750 is reporting: Current CPU/SATA Temperature: 71C Current PMIC Junction Temperature: 104C It's sitting on my desk plugged staight into the switch half a meter away via a Crestron PoE

I was seeing this but only when tied to a 3series processor. My workaround was to rollback the processor firmware to 1.008 then don't touch it, don't breathe on it, don't even look at it....

And apparently it isn't shipping so I don't suppose that any of you will have any experience!! I swore it was. Disregard the tall man...

Can anyone speak about the behavior of this keypad. Specifically when plugged in. Is it on and ready to go instantly like it needs to be? I'm talking about "100%". I have several MNET versions of

Ok - To followup, I was running firmware Version 1.000.0025 on all the panels which was released back in June or July if I remember. They recently released Version 1.000.0038. One of the bugs fixed:

I think what may be going on is that when you do a "Save As" to save your existing project under a new file name is that you have the checkbox "Unlink Smart Graphics Extenders from previous file"