开云体育

What am I looking for that might be on viewport or a older version of toolbox that isn't in the latest up to date version of toolbox?

Ran into this a while back and was stumped - thanks Eric....

Ftp.crestron.com You could probably use viewport

Been bouncing around Crestron site.? Where does one find older versions of software.? I fired up a really old laptop of mine and still have Viewport on it but no older versions of toolbox.

It is a toolbox issue. Try a toolbox from 5+years ago. You can copy them manually but you would need to create a couple of files. Much easier to just load the old toolbox

I ordered and installed a 4GB memory card because that's what the manual says it's max is.? The little tiny test program loads just fine as expected but the single page smart graphics project still

Thank You, Will send it to Bacnet guy, will let you know how it works.

Dave, Will this fix the 2-series issue, or the scheduler/Data File issue (Which I think may still be present)??

Please refer to the information I provided in this previous thread: /g/crestron/topic/105182704#msg253096 /g/crestron/topic/101801674 (

Please refer to the information I provided in this previous thread: /g/crestron/topic/105182704#msg253096 /g/crestron/topic/101801674 (

Try to grab the image here: https://vayumetrics.egnyte.com/dl/TSNYJ1aXiO

Updating this with the fix. This ended up being a heat issue. The hotter the processor got, the quicker the router would fail. Cooling it down has solved the issue.

There's nobody left there that even worked on that project...

Sure, Crestron is committed to supporting D3 moving forward....hahahahaha

I worked with a Jace contractor on a similar problem site and this is what he did on his end to get rid of a lot of the timeout failures on the Crestron side... Maybe it will help...

SwitchBot has been busy this spring releasing a number of new smart home products.? The latest is the SwitchBot Universal Remote.? This hand-held remote control can control TVs, air conditioners,

Hello Eric, Can you please elaborate into this matter, i am getting same error in Crestron side. TIA

Yea we append the filename with "Modified By xxx" so we know, and referencing the original version reminds us what module we modified.

I hit this issue a few weeks ago. The solution for me was to re-add all the keypads which forced D3 to use the latest db version. Depending on how many KPs you have I realise this may be a total PITA.

This is a known DB issue.? I don't recall the rev you need to rollback to, but a rollback is the "fix".? I am waiting for the fix as well, huge PITA.