开云体育

Probably the best method would be to only connect the touchpanel Crosspoints when a source is selected from that particular touchpanel - not when activated by Party Mode. That way, the touchpanels

I've used it successfully on a few Treo's running WM5 and WM6, so it should also work on the HTC...

The installers didn't connect pins 7 and 8. Although everything works fine with only 2, 3, and 5 on the other model plasmas there, I'll have them try it with extra pins Monday. Thanks! cable an

I just uploaded a manual for the CM6700 that contains the RS-232 protocol. I'm not sure if it also responds to the D protocol, or not, but the one in the manual is pretty simple. I just put the

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the Crestron group. File : /Documents/Pelco_CM6700.zip Uploaded by : tgoldensr

Joe While working on yachts and multi TV standards, I've had to used numerous devices, unfortunately all the good reliable ones are not cheap. I really think you will be pushed even to get a cheap one

I can't seem to figure this one out. I am trying to use HV and an old ST-CP to control x-10 lights in a particular room. I created a simple SIO that maps back to a homevision controller with the ASCII

Hi Did anyone integrate with panasonic? I have a KX-TDA100 system. Is it possible to control it? Thanks Micky

Hi Need a driver for a PELCO 6700 Matrix. Anyone can help out? Is there a PELCO D protocol available for Matrix control? Thanks Micky

It's working for me at the moment, but maybe I didn't get the update(s) you did? - Chip

Hey, it's a somewhat usable user interface, too! :) - Chip

So little? They're giving you the ability to add up to nine additional com ports to your AV2 - among other possibilities - without resorting to external bus devices. You're not paying for what it is,

anyone else having issues with econtrol? it was working a week ago and then automatic updates got applied a couple of days ago and now it does not work....

If you are trying to do absolute mouse coordinates (e.g. press the screen button you want to click directly), the CNMK won't do it. The mouse protocol is all relative. About the best you can do with

in addition, IIRC, I think there is a module in the files section associated with this group...you may want to check that out too.

I've got several that work; I'll post them this week-end.

Hi I need to control a CCTV DVR. I think that the best way to do it is with a CNMK. I want to use a TPS-2000L Touch Panel & I need to know how can I simulate the mouse via the Touch Panel? Thanks

Hello, We're doing our first HomeWorks RF job and find that there is no Crestron module that will work. The ones in SIMPL and in the files area here do not work for phantom keypad button presses or

Once again, fooguy brings the foo to its knees. Thanks Geez... its RIGHT There and all this time I never even bothered to see what it does. ChipG

If you are using toolbox, you can open up a secondary console (you have to choose that as your connection type). Viewport, just open it up and connect - it automatically uses a new socket (toolbox