¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: Problem with NEC PX-60RX5A plasma


 

The installers didn't connect pins 7 and 8. Although everything
works fine with only 2, 3, and 5 on the other model plasmas there,
I'll have them try it with extra pins Monday.

Thanks!

--- In Crestron@..., "discodan_aus" <daniel@...> wrote:

I have had some weird issues of late too with NEC panels however
nothing like what you have stated. I noticed that after the 3 series
that the RS232 connection had to be a complete cross-over cable
arrangement with pins 2,3,4,5,6,7,8 all needing connection before it
would respond. I never had to had such pins all terminated in a
cable
pre the 4 series.

I also experienced a situation where a particular unit a 50XR5M had
an
issue where if a power on command was sent back to it within 2
seconds
of its response code - the unit would stop responding and a complete
reset (power disconnect and 30 second wait) would resolve this.

If you have this all right above and have tried a full reset I feel
you have a NEC problem.

I'll post a module online in the morning that has been working very
well for me.

Good luck.

Join [email protected] to automatically receive all group messages.