开云体育

wrote: CATV is being pushed as the only remaining source of NTSC signals after 2009. Cable companies are, however, needing to compress and encrypt NTSC analog signals to free up more spectrum in their

I've seen a lot of chatter about loosing CNSX brains after trying to update the firmware. I to have lost a few but was able to get them back and had a process for updating the Brains. U need to follow

Apparently, Comcast will drop analog feeds on their cable as soon as the OTA signals are dropped. According to them, that is where they get the analog signals, and they have no intent of D/A

I am currently doing a lot of work in TN. Contact me off of the group at gchappell35622@... Thanks

That is correct, I just did a Napco about three weeks ago and it will entry Interior mode if you leave the Entry/Exit doors alone during the delay. Ross

If I understand what you're saying correctly even using new joins would not solve your problem. You need to use different signal names through buffers to drive the same end result so that other then

Never tried controlling one RS232 but I installed one yesterday, a HR21-700 and I am getting double hits on almost every command. I am using the good Master IR file found here in the file section,

Hoping someone can help - have multiple touchpanels ( 2x stx1700c and a tps4-l )with a mc2e processor...same program in all three and I find they interfere with each other - volume ramps up

Probably the best method would be to only connect the touchpanel Crosspoints when a source is selected from that particular touchpanel - not when activated by Party Mode. That way, the touchpanels

I've used it successfully on a few Treo's running WM5 and WM6, so it should also work on the HTC...

The installers didn't connect pins 7 and 8. Although everything works fine with only 2, 3, and 5 on the other model plasmas there, I'll have them try it with extra pins Monday. Thanks! cable an

I just uploaded a manual for the CM6700 that contains the RS-232 protocol. I'm not sure if it also responds to the D protocol, or not, but the one in the manual is pretty simple. I just put the

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the Crestron group. File : /Documents/Pelco_CM6700.zip Uploaded by : tgoldensr

Joe While working on yachts and multi TV standards, I've had to used numerous devices, unfortunately all the good reliable ones are not cheap. I really think you will be pushed even to get a cheap one

I can't seem to figure this one out. I am trying to use HV and an old ST-CP to control x-10 lights in a particular room. I created a simple SIO that maps back to a homevision controller with the ASCII

Hi Did anyone integrate with panasonic? I have a KX-TDA100 system. Is it possible to control it? Thanks Micky

Hi Need a driver for a PELCO 6700 Matrix. Anyone can help out? Is there a PELCO D protocol available for Matrix control? Thanks Micky

It's working for me at the moment, but maybe I didn't get the update(s) you did? - Chip

Hey, it's a somewhat usable user interface, too! :) - Chip

So little? They're giving you the ability to add up to nine additional com ports to your AV2 - among other possibilities - without resorting to external bus devices. You're not paying for what it is,