开云体育

Smart motorized shades are a valuable addition to a smart home.? However, a consumer has only had two choices when choosing shades: 1) Off-the-shelf shades that have limited options and typically

***WARNING BEFORE YOU MAKE ANY CHANGES* **BACKUP ANY FILE INVOLVED*** **THIS MEANS CONFIG FILES AND PROJECT FILES **THIS IS FOR TESTING PURPOSES

Hi All, I have not been updating CP4's to the latest FW versions as, though I don't use the HomeKit features, I have no confidence that there will be other issues related to the HK/OpenSSL that will

Was this ever resolved? I am having a different issue with Comms with a currect QSX install that's been going for 3 weeks. It seems just fine on the Crestron side - I don't see any dropouts while

The ringtone is crap. Definitely watching this thread to see if anybody comes up with a way to replace it... I'm thinking there might be another way to trigger an interrupt with logic and then tie

Good points, Eric. If I get anything tricky working I will report back here...

camera works fine with IP connection (UDP) after logging into cameras webpage, crestron control is lost requires client reboot of processor to get control back

The only way you can use custom ring tones is by setting the default ring tone off and then assigning a audio file in a custom project. Even if a -R panel let's you upload a custom project, it won't

In the file names, yes. Never been a problem before but you raise a good point. I'll check that out tomorrow.

Running signals through a buffer like that is usually done for troubleshooting purposes because it gives you more control over when signals go high in Debugger. Typically, Biamp works best when it

What if the original programmer already has a digital signal for "Initialize"?? Should I go ahead and use that signal rather than a 1?? He has it in a buffer with the digital signal for Is

Awesome.? Thanks again.

Do you have a working module?

Just curious are you using actual SPACES in your path? Not sure if an issue but did you try it without spaces?

It's an either-or situation - if you're wired to the Tesira by serial port, you'll use the RS-232 control processor module, but if you're connecting by LAN, you'd use the IP control processor module.

Thanks Gas Bandit.? I wonder if having an IP module vs the RS232 module makes any difference as far as making it easier to point to the Tesira?? In my case there is only 1 Tesira in the system, and

I did ask this on the Crestron Discussions forum, but it seems to take days to get a response there. So posting here in the hope that you guys can help out. On a TSW panel, I can send an image to the

And yet the CP3 port (and if memory serves me correctly the PRO2 port) talks correctly... They're all using MAX485 chips (or similar) afaik. I'm wondering if the issue is the timing of the DE/!RE

You might need to get an oscilloscope out and compare the Tx vs Rx levels. If Tx is working, then the only thing I can think of is it is something to do with the levels. I suspect the Mipro gear,

Yours is a very common story. The earlier modules were victim of the newtonsoft json deprecation. You don't need an analog init for the new modules, you just need a separate command processor module