开云体育

I want to embed the xpanel into another web page but this setting does not allow it. i have looked everywhere for the header setting but cannot find it so i am wondering if it is a processor level

The configuration is the following : All the TSW570P-R use a fixed IP address, like the processor (CP4-R) I Confirm that the Gateay is pingable Here is the configuration of the touchpanels : TSW-570PR

Awesome, thank you for trying it and sharing your experience with the group — I really like Python. I also really like Crestron gear. Both do something specific really well and I’ve gotten lots of

Thanks everyone, for the ideas. Michael, that MQTT module is very cool! I tested it and it works as advertised. Great for temporary debugging with MQTT Explorer. Have you thought about building the

I'm aware of the Zone Status driver, but it didn't work. I also checked the notes in the dat file which state it's not supported. Did you use it with a Neo panel? They updated the Neo driver last year

P60s cannot be controlled “stand-alone.” It must be connected to a cisco codec. The camera controls will need to be sent to the codec which in turn passes the command to the camera.

I have up loaded all I have on the LiteTouch Standard CCU including the? protocol.? You can find it at /g/crestron/files/LiteTouchStandardProtocol.zip

The following files and folders have been uploaded to the Files area of the [email protected] group. * /LiteTouchStandardProtocol.zip (

<Never Mind> I got it. Kinda

Hi Doug, Ecobee notified us they do not allow people registering as developer anymore. Until they sort it out, we took the driver down, the Hubitat module seems a good solution. Cheers

There has been a zone status module added awhile ago, CRESTRON CERTIFIED DRIVERS SECURITY SYSTEM ZONE V1.0. Worked well and pretty fast to report last time I tested last year.

This is a bit crazy, I know, but does anyone still have modules and the protocol documentation?? I could use it for a takeover project and I need the integrate the Litetouch.? The existing program

Hi; First, I am assuming the LED has 0V when it is off and 1.94V when it is on. Second, that LED also has a series resistor to limit current. ?The other side of that resistor may have a substantially

We checked IP 192.168.0.100. But camera has no IP without DHCP server. We did factory rest also and did IP scan also.

Today, there are 2 new articles I've written that have been published by Residential Tech Today on their website. First, in April I wrote an article on my initial experience using the Navimow i Series

Hello @CHP2, We've had this problem since September 2023 on several installations equipped with TSW-750, TSW770, TSW1070 and TS-1070B + controller CP4N, AV4 and RMC4. Since September 2023, we updated

As far as I understand, this camera is only controllable when connected to the Cisco system, not stand alone.

What's the network situation like, i.e. is there a pingable gateway (router) employed, are the devices reserved DHCP or statically assigned? This might not be the issue but I have noticed with all

Documentation says it should automatically obtain an IP address, otherwise the default is 192.168.0.100. If it works on your own DHCP server but not the LAN, there might be something wrong on the

Hi, We are trying to control the Cisco P60 camera standalone over TCP/IP. But we are not able to find the IP address of this camera. We create DHCP server on our laptop and assign the IP address to