开云体育

FINALLY!... From my case: " Apple has released the latest version of Crestron Go which addresses the crashes associated with the rotation issues on later versions of iOS.? If the phones or tablets

Please ignore this thread. I pulled the plug and reinserted again, and then voila, everything works as expected! Sorry to bother you guys!

Hi all, we initially planned on using Cisco CBS350-series switches?as a switching backbone for Crestron NVX (being the "recommended follow-up" of the SG350X series for which Crestron's answer

Sorry, I need to take a step back. Previously I claimed that the socket connection was successful, I was actually wrong. I had an IP-ID TCP/IP set previously, thus the connection was successful. Now I

The first thing to check is make sure Standby Mode is set to Communication On. You'll find that under Menu:Extended:Standby Mode. I would also turn the projector on manually and see if you get

I was just trying to turn on/off my HT projector to no avail.... I was using Crestron Certified Ehternet Driver for the projector (Crestron Certified Display Ethernet 2.0 (cm)) I use the

Phil, Three things I found while working with Nucleus: 1 If you have not yet worked with the hardware, you will need to note the decoder output type. TRX and RXS decoders differ in the HDMI output

Thank you for the help. These are the same steps that I went over with the Crestron support agent. It worked perfect when I used a new account but is still blocking me using my original account. This

Hi All, I've had a number of TSRs that will get into a state where I can't even connect to it with console or discovery... BUT, They are pingable, Online with the processor (IP-ID) and show up in

Thanks Phil, I got it to work. Tested with hardware and it's woDidn't so far. Didn't yet add parsing for feedback. Tray

Hi Tray, I'm working on a similar project that is being implemented this summer. Evertz keeps their API very close to the chest but it's nothing special. I think it was more painful getting the info

Not having "No span tcn flood" applied to all interfaces is the most typical culprit assuming. IGMP is correctly deployed Also for the querier note that -all- multicast traffic is forwarded to the

Answer ID 1000314 provides detailed configuration instructions for Cisco (and other) switches. Cheers, Thorsten Von: [email protected] <[email protected]> Im Auftrag von proggieus Gesendet:

I'd start here: https://www.crestron.com/getmedia/94a25ed5-6580-48df-a152-4cdc043820ed/dm_nvx_network_min_requirements_1

I have a larger NVX Install that were are in the first stages of turn up. I am dealing with a corp. IT guy who has never done NVX before- the final system will be 40 TX and 80+ RX we have 24 RX online

That particular message is most frequently attributed to username case-sensitivity mismatch. Please check what was typed against the " *Your Username* " field on the *My Profile (

*Crestron MasterInstaller – Common Troubleshooting Tips* When troubleshooting MasterInstaller software downloads, please check the following: 1) Software Version Please ensure the latest

My latest article, "Exploring Delos Air Filtration Systems for Home, Work, and Travel” is being published by the good folks at Residential Tech Today Magazine on their web site. Delos is a global

We have had this issue resolved by updating master installer to v 4.00.10. Hope this will help.

That’s correct. I had the same issue with a VC4. Called tech support and they told me to set the gateway same as processor IP. It’s a known issue and they are working on it. Wilson Fernandez |