开云体育

Now if only I had a Pro3 at home instead of a Pro2 I might know this ;) -- Lincoln King-Cliby, CTS Commercial Market Director Sr. Systems Architect | Crestron Certified Master Programmer

I have confirmed that control of the monitor is possible using only pins 2,3,5 from a laptop to the DB9-2.5mm adaptor at the monitor. However, still no luck with control from the MPC panel. Maybe

I haven't encountered that problem (yet), but this is good to know. Thanks!

I've always experienced what I assumed was crappy RF when using RTI remotes with Crestron. However, I just discovered the fix. In Integration Designer, if you go into "Properties" for any button

IR emitter

3000km from somebody with a brain is a lot closer than 10km from a wealthy customer that doesn't WANT to deal with a firmware upgrade. Blessed are the commercial accounts.

I have usually multiplied everything by 100, then run my equation and then correct the output back two decimal places.

I don't believe that will work. While it is running a solution, the system does not retrieve new values from the internal queues that hold the values from the hardware. So when you compare the

In the 3 series, in SIMPL#, you can do floats, just for what it's worth.

Has anyone worked on an alternative method of control? serial/USB dongle doesn't seem to work.

Having same problem with a NEC E533. I got a DPMS-200C using the RS232 on a DM-RMC-Scaler. Bump

They are sharp, not pioneer.

I'm not sure but i think it's pionneer. Do you have a part number behind the display who could help us to help you. {Paf} Le 13 juin 2013 10:13, "Mike" <mikelumer@...> a 閏rit : [Non-text

Directly from my laptop via VPN connection. No onsite PC :)

Haha.. as i thought! Been doing a lot of AMX lately and kind of got used to at least some level of robustness ;-)

Neli, do you have VPN access, and you're using your own computer or a PC onsite that you can remote into somehow? Chris

Have you tried a different HDMI cable?

You can have as many ECCONNECT Symbols as you want. I have one per CCROSS. Ignore what Crestron says about it, and throw out the ideas about using a stepper to create the

Thanks Joseph, yes I triple checked that I don't : ) Thanks Neil, that makes sense. -- Sebastian Marszalek

Refer to my crosspoint flowchart for reference: https://www.lucidchart.com/documents/view/453b-0cc0-51266ec0-a956-34730a004d18