开云体育

Yes, this works without any problems. From: Crestron@... [mailto:Crestron@...] On Behalf Of metdeathx Sent: Saturday, December 22, 2012 7:12 PM To: Crestron@...

Samsung UN65ES8000

Which DI box do you have? Are you using a balanced output? How are you wiring that to an RCA? Typically you'd tie - and ground (pins 1 & 3 in an XLR) together for the RCA ground. Chris

My 42" LG has it and the protocol works well enough. I want to put a 65" in the family room and would like serial for that also. I don't see any new ones that list that they have it even if it's

I would say start trouble shooting the audio playing first. Plug the output Into something you know works to make sure it plays your wav then once that is good then troubleshoot timing issues. Nick

Yes. There is a delay. I just did this with AAE's instead of bipad but I had to put 2 seconds of dead air at the beginning of my mp3. I played mine off of an mc3. Sent from my iBerryRex. RAWR

I'm using a C2N-IIF loaded with a WAV file to drive the local doorbell speaker of the C2N-IIF as well as feeding the speaker audio from the C2N-IIF back into the house into a BIPAD. On my test bench

Page rendering performance seems to be lacking, so I am looking at ways to make page flips faster. To get this out of the way...I never use page transitions so that is not the problem. I've noticed

Howdy, 1st, I have only been a member for 2 weeks or so and have learned a ton on this site, so thanks mods and members. Much Appreciated. I am working on an MTX-3 and have a question about the system

Thanks, I figured it was an easy fix.

Thank you Tony Golden! You gave me the clue I needed, that the Mobile pro symbol was under Ethernet touch panels. I looked all over simpl and just could not find it. Once I used that symbol everything

You are welcome to alter the one that I posted, quite a while back, for the LC-65xxxx From: Crestron@... [mailto:Crestron@...] On Behalf Of jcdigitalmethod Sent: Saturday,

RSPW1[SPACE][SPACE][SPACE]\r - format dictates 3 spaces "syntax"

If you're controlling them over ethernet, you need to send "RSPW2 \r"

That's good to know. Thanks Tony. I wish we had a forum where we could make this post "sticky". I've always wondered the differences but they all seemed to work so I just pick the shortest one. Nick

In programming, Android devices are setup exactly like iOS devices. In Simpl, use the Crestron Mobile touchpanel symbol. In VtPro, you can either use Mobile, Mobile Pro, or "for Phones" for iPhones or

2 series as a slave are CIP. They're not Gateway. As such you have to put the IP Entry in the IP config tab in SIMPL before you compile it if you expect to upload it w/the program, or you can do it

When I compile and load the program to the cp3 the ip table does not include the eslaved pro2. If I manually enter the ip table entry it works fine, however the pro2 shows up as CIP instead of

I've been away from Creston for a while now after I bought the new house.....I'm looking at resurrecting my Vidmux for something that crossed my mind.....i can't seem to find the PDF for it anymore in

After looking through simpl and vtpro, I can't seem to find the appropriate symbols and panel type. In simpl I find a number of ipad/ipd/iphone Ethernet devices but no "Mobile pro" device or a