开云体育

I *do* come from the electronics engineering world :), and you're correct Jeremy. It's to do with different forward currents passed by wiring just the LEDs in parallel with no series resistors...the

I happen to have a Marantz SR-7005 here in my office for testing. Marantz now uses the Denon codeset, which works great (connects on port 23). Except for one thing - the ethernet port shuts down when

Great - I tried to find the 1/8" mini on the back, but couldn't find a picture that had it. Glad I don't have to build anything to attach to the VGA port!

I've now done about 12 of the C6300/7000/8000 series in the field. the Ex-link is NOT in the VGA connector.... The Ex-link RS-232 port is a dedicated stereo 1/8" connector on the rear of the TV that

I'm not an electrical engineer, but paraphrasing what I've heard before, IR LEDs have different resistances due to manufacturing differences, even if they're the same make, model, and batch. If wired

That's the default, but there's a "bypass" checkbox you may have seen show up in Toolbox recently that bypasses that behavior so that a single program can be restarted without affecting the others.

I just updated to SB 3.10 with new templates, updating a previous SB 3.09 project to 3.10 i am no longer getting feedback from my AUDIONET card. Anyone else see a similar issue?

I think in your model the ex-link is in the VGA connector. http://tinyurl.com/4slyvt2 From: Crestron@... [mailto:Crestron@...] On Behalf Of Phil Bridges Sent: Friday, March 04,

Has anyone worked with a marantz NA7004 and created a module?

You can also run wireshark. You would need to setup filters for the traffic you are interested in.

I'm sure someone else can explain better, but any dual-emitter you buy is wired in series. (I think I discovered it when troubleshooting a dual-emitter that had one broken emitter lead. Both stopped

Wait a sec... Are you stating that any program loaded into a higher slot than the slot being loaded through toolbox will automatically be suspended/restarted (as in reboot on 2 series) while/after the

Thanks I always forget about that device extender

Hi, I used the same solution, but even a bit further: For every page I wanted to create, I made 2 subpages, one with the actual source chosen, and one to choose sources. The biggest subpage had a

The model of the TV lift is a PLD-Studio MOBO-S50 which fro what I hear is not that great. http://www.pldstudios.com/products/mobo/s50.html I called the manufacturer's technical support to verify if

Toolbox will tell you all of the Crestron devices it sees on a network - use the "Device Discovery Tool". [Non-text portions of this message have been removed]

I've tried to find a good picture of the connections on this display, and I've been unsuccessful. Can anybody here tell me whether or not I'll have any luck getting a serial connection up and going?

Heath, This may be a dumb question, but why do you need to wire them in series, rather than parallel? Travis

I agree with Chip, Extron's stuff just works. The dip switches which set your voltage range on the VA's are muy importante.

Also, if this helps - the cue that you'll need a parameter when sending a command is illustrated on the chart with "***"s in the Control Command column... - Chip