开云体育

Good call Mike, pointing out Cresnet not being twisted pair. I didn?t think of that. Cheers, Thorsten Von: [email protected] <[email protected]> Im Auftrag von Michael Caldwell-Waller via groups.io

Just having done this before as an experiment, I would avoid assuming 100Mbit Ethernet will run over any 4 wires, even with Cresnet cable’s shielding. 100Mb Ethernet takes a noticeable hit in signal

For a very inexpensive option, I've used these - https://www.amazon.com/dp/B07G194BQD. The oldest site was 3 or 4 years ago, with no reported issues. The only other model I've used are the NVT, which

I don't have an Hz to test but with other keypads, Each button is registered separately so you can P+H one and Press another in SMW. Now with the 'Split' Button I can't say for sure, but since they

Oh, I wasn?t aware this was referring to an old thread reusing Cresnet wiring for Ethernet/PoE. As Cresnet is 4-wire and standard 100Mbit Ethernet is based on 4-wire (even with PoE), it shouldn?t be

Thorsten, I don't think that's going to work. I'm pretty sure that the DIN-CENCN-2-POE only takes an ethernet comms to serve Cresnet devices. The thread is about using Cresnet cable (or any 2-wire

I have numerous sites with UI cameras and I use the following stream, very similar to what was already posted but one notable change (in red): Example - rtsp://192.168.0.xxx:7447/[

DIN-CENCN-2-POE Cheers, Thorsten Von: [email protected] <[email protected]> Im Auftrag von mark kaye via groups.io Gesendet: Freitag, 23. Mai 2025 13:18 An: [email protected] Betreff: Re:

I did reach out to Crestron and they told me to reach out to SI as they cover issues with the driver.

is there a current solution for Cresnet to Ethernet + POE?

Hi Lincoln, Hm, that?s very interesting. I?m just starting to deep dive into this topic, so this might be the difference between theory and reality. However, both the links you provided are 5+ years

Have you raised this with Crestron True Blue Support?? That would seem like the right place to report this type of issue - especially as if it works in one UI platform, but not another, it's more

Im pretty sure Sony have discontinued Simple IP Control protocol in alot of their screens.? Definitely the lower end TV models they have. They are supporting the Rest API in all of them though.

I have a similar problem on an existing install where the tech changed the name and now player A is no longer usable via the control system. Changing it back didn’t work. Is there a way to restore

console into the MMS on port 5004 and send the command "BrowseInstances" make sure the player you are working with is actually named "Player_A" It is possible to change this name in the web ui under

Thorsten, My impression/experience has always been that that actual multicast traffic flows to the querier – and this Reddit thread matches my experiences:

Also, make sure you have all the settings in the display correct.? There are several settings in several places.? Don't remember them all offhand but they gotta be right or it will never connect.

I had 3 of them some months back that had a problem with the connection.? Port 20060 worked but all 3 would periodically drop offline and stay offline till I did something like unplug the display or

You will need to setup port forwarding and the port number to the stream Michael Restrepo | Owner Restrepo Innovations 825 Windham Court North Wyckoff, NJ 07481 Office | 201.925.0059 Direct |

What port did you get these commands to work on? I also cannot get a connection on port 20060. Thanks