开云体育

Should the syntax be ka 01 00 \x0D?? Or, should the syntax be as ka\01\00\x0D?

Hi, Although the commands to control the AXI are Extron standard DSP commands, the control method is different: Dante is used. Unless you are a Dante developer there is practically no way to get any

High blood pressure is dubbed the "silent killer" because it often presents no noticeable symptoms for years while silently damaging blood vessels and vital organs like the heart, brain, kidneys, and

It’s basically a 8ch relay so yes it can. I use it to switch many different items - as long as it can handle the wattage or use it to control a contactor which has larger switching capabilities.

Hi All, I just did a TBx Discovery Tool/Remote Search via the local processor and it returned (2) instances of the CEN-GW1 - Same IP and Host name. I hadn't noticed this before. Is this 'normal'??

I am sending these via a BPC-8.? I'll try the xx xx xx\x0D instead of 0x0D.

I have always sent ka 01 01\x0D And ka 01 00\x0D without issue Perhaps try in that exact syntax? Sent: Tuesday, May 6, 2025 2:16 PM To: [email protected] Subject: Re: [crestron] Transfer Project File

If these are in a SIO then it should be \x0d

So these are the rs232 commands I am trying to send to the LG TVbut none are working. Power On = ka 01 01 0x0D Power Off = ka 01 00 0x0D HDMI 1 = kb 01 08 0x0D HDMI 2 = kb 01 09 oxoD I also tried the

HI guys, I'm trying to control AXI22 AT D dante interface, thought that it would be easy as Extron has very clean SIS command for every product of theirs, but this has given me issues, where the

Make sure you eliminated and replaced every single vestige of the 4.2 modules, including all the CLZ files. Physically deleted. It's not enough to just remove them from the programming logic, they

Awesome!? Worked like a charm.? Thanks.

Once the desired configuration file is loaded onto the BPC-HPLIR via the included USB cable, it can be transferred to a BPC-8 unit by completing the following steps: 1. Remove the clear plastic dust

Thanks Anthony, but the HPLIR comes with a toss link cable to connect to the button pad.? I am just seeing how or where the connector goes.

Hello all, I am having this same error in a system that has been running for? years with v4.2. I updated to v5.2 and did not fix. Did anyone find the fix for this errorr? Error: splusmanagerapp.exe

It's a switch and the load will be low with LED's. I see no reason why not. Should be fine...

Can it a DIN-8SW8-I switch 230v LED light globes?? The specs state the following but don't mention LED globes. The Crestron? DIN-8SW8-I is an 8-channel lighting control module designed to support

Ive always used a usb cable to transfer to the bpc-8

How do you transfer your project file from the HPLIR to the BPC-8?

Thanks so much Gary! Ordering the IR to USB and will give it a go and report back on what I find.