开云体育

You’re welcome! Like you I couldn’t figure it out so I called TB thinking I was getting an RMA for a bad Pro4. When the guy I spoke with told me to shorten the Hostname I thought he was

OMG, Thank you so much, TB after hours still has not called me back since 5am this morning? Sent from Outlook<http://aka.ms/weboutlook> Sent: Saturday, February 24, 2024 2:56 PM To:

Good to hear. When you update the firmware on the flex do you have to re-install the QSC msi?

Tony is right, the only way to have an empty string parameter default to "" in SIMPL when you drag in a module is to do what Tony said, edit parameter properties (in .umc) and set default value to "".

Ran into something similar the other day with a PRO4 and relay cards. Apparently the cards communicate over IP through the processor and since they were developed for the 3-Series they fail with

They show up in Text Console with the cards or showhw commands, all looks good, there are led's on the front for Slots 1,2,3, they are flashing green which is a little concerning I guess Sent from

Do they show up when you look at the front panel to see the installed cards?? (I'm assuming that you can do this like on the old Pro2's...)

Uggh, does not seem to matter Sent from Outlook<http://aka.ms/weboutlook> Sent: Saturday, February 24, 2024 12:08 PM To: [email protected] Subject: Re: [crestron] PRO4 with C3-IR Is the source code

Have you tried wrapping it in a umc, then setting the parameter properties in Simpl?

Is the source code compiled for both 3 & 4 series? I don't know that it makes a difference...Just a thought.

Thanks for the suggestion. Unfortunately it didn't work. --Devin

Correct, They are brand new C3IR-8 cards, I have 1 card in a PRO4 and 2 cards in a different PRO4, none of them work Sent from Outlook<http://aka.ms/weboutlook> Sent: Saturday, February 24, 2024 10:44

Just to confirm, you're using C3IR-8 cards with your Pro4?? the Pro2 used C2IR-8 cards that are not compatible with the Pro4...

Hi, I was told by TB support that they are investigating the possibilities. If the internetradio service can be reactivated or if there is a possibility for an other. But for the moment it‘s down

Onsite to upgrade a PRO2 to a PRO4 with a C3-IR card in slots 1 & 2, I don't seem to be getting any output from the C3-IR, i have checked the firmware on the card and it is up to date, latest firmware

I'm not sure if this will work for you without doing a bunch of testing, but it sounds like S+ believes that it is OK to put a 0d in your parameter field that should only be accepting a string. Try

We regularly have to integrate either teams or zoom with crestron, and indeed it is complicated each time. It's been a while since I interacted with Zoom but it seemed to me that you could stay on the

I've written a Simpl+ module with a massive amount of string parameters and to make the module as user friendly I would like have them fill with "" by default. I've tried about every combo I can think

It's the same output. There's a special section in the remote's Setup Menu, where it can be registered to use one of the cloud processing services - I believe only the TSR-310 has this. Once

I have installed the QSC msi and it ran along the Crestron software.? The QSC control will take priority for the flip page.? Been running for 2 years.