开云体育

Same, has been very frustrating . Even worse if you're using more than 1 program slot, can pretty much count on it failing. I'm in the habit of using the STOPPROG or KILLPROG command every time before

Hi All, I've been using TeamViewer for a number of years, paying the high price, and it was worth it compared to the lower price/free options. I've found it to be less performant and I definitely

I think that the Application Market has some add'l graphics for SG...not sure if there's the round element that you're referencing... FYI, HOME is a thing unto itself, it does not use SG...

Make sure you aren't experiencing any wifi interference with the Gateway.? Is there a WAP nearby?? Try changing to channels 25 or 26 on the GWEXER.? I've even had to disable 2.4 radio on WAPs that

Specifically: Press-Press-Press-HOLD Also of course, make sure the target GW is in Acquire mode

Just got into the habit of stopping all programs before uploading but yes, it's been like that for the past 6 months or so

It's actually a four press and hold on the last press for about ten seconds until the green led flashes. Corbin.Lovering@...> wrote:

Greetings all, I have a HR-310 that went out and we are looking to use a different remote paired to a different GWEXER to get his master working. I followed the steps to pair with triple tapping the

Dears, Can anyone tell me if we can a "Setpoint Selector" like the one in the below link on VT-Pro?? I believe this screenshot is for the Crestron Home OS, but it would be very helpful for me if it is

I have one site that I confirmed still works.? I'm wondering if there was a software update and perhaps the one site that is working wasn't updated yet.

I've tested 3 different sites this morning and found the HaikuFan 2.1 module is no longer working.

I thought it was just me. I'm on site and working my way through 25 apartments. CP4 connections either through USB or Direct network connection in Toolbox are painfully slow. Usually I'd just FTP the

It's been kind of random and I haven't really put in the time to pinpoint firmware versions between processors, but over the past month - two months i have been noticing quite a few failures to load,

Great Info.? Both processors are 4 series and when I did updates in August, they were uploaded to D3_Pro folder in NVRAM.? Today with the latest updates, the files were loaded to the root NVRAM.? I

D3 will always use \\NVRAM\\scheduler.dat as the file path in SIMPL. On 2-Series this corresponds with the location \NVRAM\scheduler.dat On 3-Series/4-Series this corresponds with the location

I made an update to the scheduled events.? I connected with toolbox and noticed that the updated files were loaded outside of the NVRAM\D3_Pro folder and that the old files were still inside the

The project I did this on has only been running for a few weeks. It has not been long enough to tell if it actually fixed anything.

Eric, Have you found the 'Restart' to reliably restart communications on a single player that has gone off-line? I assume that you have some logic to pulse RESTART when the unit registers OFFline

ENABLEFEATURE cmd is used to turn on/off services in Prog0. HYDROGENMANAGER is XiO Cloud. CLOUDCLIENT is MyCrestron Residential Monitoring and/or Fusion Cloud. (The 2 cmds correspond to the 2

I've had a couple requests so here's my example ( /g/crestron/files/AppleTV%20Example%20v1_archive.zip )