开云体育

Thanks Andy! I looked at the S# documentation and didn’t see that. I’ll take another look. Thanks again Jay

I have an Alienware laptop and use a WD19TB docking station. In my case I run dual 4K monitors, use the ethernet and every USB port on it. I bought 2 units off eBay at a tremendous discount off retail

on the HTTPClient you can set the TimeoutEnabled property to true and then set the Timeout property to the timeout that you want in seconds. If you set TimeoutEnabled to false then you can set your

looking to add a Dell docking station to my Precision 5560 laptop. Found the Dell WD19TBS, Dell J00G9-Thunderbolt Dock TB15 and seen several out there that range from $66 up to $500 that all claim to

Every time I have run into this problem, which has been more times than I care to count, I have always traced it to a problem with settings for the target control system in unc and s+ files. If you

Hi All, So the ultimate take-away is that I should suffer what I know and not try to eliminate and suffering...:( I tried moving to work only with project libraries, because my ancient/bloated SMW

2nd MC3 - clone of original card (other was same clone with mac address changed) this 1 on power up does nothing until i hit HW reset updated firmware OK, but doesn't recover from power fail

Would love an update!

Hi, Anyone has control command for this model? Can`t find anything from Barco website. Thanks

When using an http client to make a request to a device in S#, is there a way to adjust the timeout before the Crestron system throws an exception that device has not responded in a timely manner?

Yes, that’s what I was trying to convey here: /g/crestron/message/243850 That module already has the correct input names as used by the new RX-AnA units I think. Rather than

Thanks Jsells, I have all the protocols, what I don't have is the "Desire". This job is a domestic and a very rarely do domestic so I know I will never use it again. That's why I am spending too much

I believe that we're finally in the clear, with a short-term caveat - I'll verify that I can post what I know on monday...

Just a follow-up regarding the RX-AxA series of AVRs... The 'Yamaha RX-A3010 IP v1.2' module seems to work fine... BUT It does not have the commands for the HDMI inputs. The previous generation of the

YXC is just a HTTP API and by my understanding is similar if not the same as MusicCast API. When I was testing the CCD for my RX-A780 I was able to confirm with network captures that the device was

HI, Can someone confirm that a NVX-363/NVX-360 accepts 1080i 50Hz ? The specs shows 1080i 30Hz in the common resolutions. Thanks Best regards Chris

I've run into the same results on this... Have a customer that has 2 of these thermostats and I have a DIN-AP3 Running old firmware and can get one of them working but not both... I get no where with

For reserved joins you can subscribe to the signal name instead of using the reserved join number when working with CH5. I (among others) use:l something like this: CrComLib.subscribeState('b',

So I've gotten my Ch5 angular project to upload and show up on the TSW1060. I'm trying to detect if the touchpanel is Online with the system... reserved join 18494. But all i ever get is false, even

Ive used the YNCA protocol on both RS232 and IP. Both worked exceptionally well. I am doing a job at the moment where I am controlling 10 WXA-50's. These are using the new YXC protocol. I haven't