开云体育

Yes, only nitpick is that the -transmitter- needs to be set to autoswitch (the out of the box default) to allow either VGA or HDMI to be connected; there is nothing in the scaler to switch...what

Quick one, if I tie the < digital output to a trigger email event will it send the email just once, or continually send it until the < is no longer high? Cheers

Yea I got one on eBay today for 65$. Am I the only one that has a stock pile of equipment left over from jobs and its never what I need.... ? Lol Thanks for the help y'all.

Perfect - exactly what I needed. Thanks Chip

ACOMP2 and a debounce to make sure the temp is stable before triggering the email? - Chip

What's the best way to trigger an event based on an analog output from a C2N-RTHS sensor? The sensor has one Temp and one Humidity output, and I'd like to send an email when temp gets below 12

I took a quick look while eating lunch after shoveling some snow… Disclaimer: I don't know anything about this device or its 7400 line S+ module. I did notice that it has been substantially modified

Also, I have had similar networking issues with using the LAN's PoE switch to supply PoE power to DMCO-55 cards, when connected, I would intermittently loose connection to CP2E, then disconnect PoE

I believe this install is Cisco from head to toe, with some very experienced network guys setting it up. I'm kind of curious about rolling back from 4.007. I know re-compile was necessary after 4.007,

All Static. Got burned and learned my lesson about avoiding host names years ago.

Just FYI, I just finished fighting the same type of issues. All of the sudden I had the same network problems with multiple, non-connected, systems. Come to find out, there were two main issues.

Most definitely will work. Use this setup for most of the conference rooms we install. -- Yours truly, Victor

Does anyone know if this will work... A dm wall plate and a dm scaler only. No processor. Set the scaler up for auto detect to allow vga or hdmi to be plugged in. Thoughts? Thanks Thom

Contact me on my personal mail Marselle001@... Crestron CAIP

The answer availble rg_2-series_control_systems.pdf in the crestron web site page 18/19. if your problem still exist let me know on my mail :marselle001@... Rabih Brahim Crestron CAIP

To Make the web xpanel work please follow the steps below: After Compile , open xpanel web folder and delete every file has 64 , mainly they are 2 files : XPanel64 XInit64 then it should work ! Rabih

hello every one, below is the model number of the IP camera Type: PTX model number is :PBACM - PT300 (3 MEGAPIXEL PTZ DOME CAMERA)

Good catch, I didn't see/read the "ST" part. Yep, must be the 1-way gateway.

Are you using static IPs in your IP Tables, or hostnames?

Have you tried disconnecting the panel from the network and then try to ping that address and the same for the DMPS? Check to see if you have an IP conflict.