Also, I have had similar networking issues with using the LAN's PoE switch to supply PoE power to DMCO-55 cards, when connected, I would intermittently loose connection to CP2E, then disconnect PoE feeds to output cards and it cleared up. Also throughput on the LAN dropped significantly. Using PoE injectors solved the problem.
toggle quoted message
Show quoted text
--- In Crestron@..., "innoventgroup" <innoventgroup@...> wrote:
Just FYI, I just finished fighting the same type of issues. All of the sudden I had the same network problems with multiple, non-connected, systems. Come to find out, there were two main issues. First, I had ADMS's at both locations and both were a major contributor to the problem. I could unplug them and the problems went away, plug them back in and the problems would return. Also, another culprit was the 4.007 firmware update. And, finally, the center point of the problem was a Netflix 8 port gigabit switch. I switched it out for a cisco 16 port gigabit switch and all is well. I still get errors on the 4.007 firmware but they are not killing my systems anymore. By the way, you can get rid of the 4.007 errors by rolling back the firmware to the previous version. I hope something in my babbling will help.
Take Care,
DAVE
--- In Crestron@..., "toritian" <toritian@> wrote:
Has anyone else experience weird network connection problems between Crestron equipment with recent updates?
I have had DM Router issues, where it will show the DM Router as being offline until I reboot the DM and then it pops back up online in the IP Table.
This happened in multiple locations with multiple programs/DMs.
On another site I have CP2E running lights talking to another CP2E and I'm having a hell of a time getting them to talk to each other over an EISC.
A reboot of both will usually connect them up for a while, but then they will stop talking.
One processor is showing a status of "UNKNOWN" and the other shows a connection status of "NO_NETWORK", which I don't remember seeing before.
I gave up using Direct Sockets because they seem broke, but this is just basic Crestron 101 falling apart.
