开云体育

Thank you for the help. These are the same steps that I went over with the Crestron support agent. It worked perfect when I used a new account but is still blocking me using my original account. This

Hi All, I've had a number of TSRs that will get into a state where I can't even connect to it with console or discovery... BUT, They are pingable, Online with the processor (IP-ID) and show up in

Thanks Phil, I got it to work. Tested with hardware and it's woDidn't so far. Didn't yet add parsing for feedback. Tray

Hi Tray, I'm working on a similar project that is being implemented this summer. Evertz keeps their API very close to the chest but it's nothing special. I think it was more painful getting the info

Not having "No span tcn flood" applied to all interfaces is the most typical culprit assuming. IGMP is correctly deployed Also for the querier note that -all- multicast traffic is forwarded to the

Answer ID 1000314 provides detailed configuration instructions for Cisco (and other) switches. Cheers, Thorsten Von: [email protected] <[email protected]> Im Auftrag von proggieus Gesendet:

I'd start here: https://www.crestron.com/getmedia/94a25ed5-6580-48df-a152-4cdc043820ed/dm_nvx_network_min_requirements_1

I have a larger NVX Install that were are in the first stages of turn up. I am dealing with a corp. IT guy who has never done NVX before- the final system will be 40 TX and 80+ RX we have 24 RX online

That particular message is most frequently attributed to username case-sensitivity mismatch. Please check what was typed against the " *Your Username* " field on the *My Profile (

*Crestron MasterInstaller – Common Troubleshooting Tips* When troubleshooting MasterInstaller software downloads, please check the following: 1) Software Version Please ensure the latest

My latest article, "Exploring Delos Air Filtration Systems for Home, Work, and Travel” is being published by the good folks at Residential Tech Today Magazine on their web site. Delos is a global

We have had this issue resolved by updating master installer to v 4.00.10. Hope this will help.

That’s correct. I had the same issue with a VC4. Called tech support and they told me to set the gateway same as processor IP. It’s a known issue and they are working on it. Wilson Fernandez |

Lincoln King-Cliby I still think it is something people are doing. I have never had the need to run a time sync module in any of my programs as the time was always correct. I have always put a clock

Thanks a lot, I did not think about doing that but I will set it up this way and see what happens. Thanks again!

Wow .. I'm having the same issue with an RMC4 and 4 TSW-770, all 4 disconnecting every 3-4 minutes. Been troubleshooting the network runs and my program for hours. Looks like changing the gateway to

Historically whatever the method of timekeeping Crestron used (not sure if it was a crystal, a software routine, or a combination) was not the most robust and was also heavily processor dependent. I

I hear of people talk about Crestron not keeping time. I have both 2 series and 3 series lighting systems that are not connected to a network at all. I have never heard of a complaint from any of

I agree with Tony. For some reason on a lot of the newer firmware and devices, if you don't have a pingable IP address as your Default Gateway, you will run into issues.

Hi Olivier, I had to set the default gateway on the TSW series panels to the IP address of the processor to stop the random disconnects. It's been several weeks and they've all (10+) been stable