开云体育

Also check TIMEDATE / TIMEZ / SNTP settings on the PRO3 to ensure the time & date match the mobile device. If the PRO3 has AUTH+SSL ON (and SSL was enabled in CGo/CApp w/ the auth creds entered), then

Yes, My initial tests show that things are good now...However, the nature of this issue (Floating Neutral, etc) is intermittent so I will report if any other problems occur. And of course I would hope

Thanks for the tips, I've been looking at other BNE, yabe reports fine with Coolinkbridge ID64 with firmware 0.3.4 but nothing with new devices we have 3 off with firmware 0.3.8, just noticed this

Just wanted to share that I've discovered that Wired Wake On LAN can be changed without the remote control by sending the "fw id data" command, where data is 00(Off) or 01(On). For example, "fw 01

So, going on UPS power worked now?

Just a follow-up. Today I updated my PC-350V's with the latest/new FW to resolve (Hopefully!) the issue noted in this thread. Obviously its too early to tell how things will go, but initial tests seem

also check on the iPad settings, scroll down to Crestron Go, make sure "use local network" is switched ON.

I have been unable to get Dolby Atmos to work from an Apple TV using NVX encoders / decoders.? Just updated NVX firmware to 7.0.? I've tested with both a McIntosh MX-180 and a Yamaha CX-A5200

I had some issues with YABE, only one CMNgw at id 64, but yet not discovering, etc. I tried with also with BDT (bacnet discovery tool), and it reported the units fine. It didn't report the information

If authentication was enabled in the PRO3, check if IP got blocked. 'Remblockedip'

Greetings all .I had an app project working fine .it was local only .suddenly stopped. Says connection refused .I have updated firmware , all data bases still says the same .any ideas ? Its on a pro3

Microsoft released an update which should fix the issue: 2022-05 Cumulative Update for .NET Framework 3.5 and 4.8 for Windows 11 for x64 (KB5013628) -- Crestron Service Provider - TBD Enterprises Inc.

SIMPL+ NVRAM allocation was introduced in CCD Disp Eth v1.14. (F1 Revision History calls out "Added ability to page through more than 10 user attributes.") SIMPL compiler calls out max NVRAM

Well must be a hold over from 2 series in Simpl, crisis averted.? I checked the PRO4 and it actually has 3MB of NVRAM.

Hi there! You would use the feedback signals of the?Lutron HomeWorks QSX Button Control v1.1 module. The outputs of that module will go high when the corresponding physical Lutron keypad button is

Learned a valuable less today.? I am using the Sony IP CCD modules for both TV and Receivers.? Apparently they are NVRAM hungry.? Each CCD allocates about 10KB of NVRAM.? I am just updating a

Thanks for all the advice and suggestions! I ended up doing what Dave H suggested (one of his suggestions) and made my magic packet string in Notepad and copied/pasted into an SIO. I had to put a 1 on

Cool automation and Crestron Home BACnet, YABE We have 1 CoolinkBridge ID 64 showing a HVAC system detailed BACnet data for Thermostat - operation is good in Crestron home? YABE show all BACnet info

I should also add that the Shelly TRV can be fully controlled through the Shelly app. Thanks Jay [email protected]> wrote:

Correct. All Shelly devices communicate directly over WiFi so they don’t require a hub And, the Shelly drivers I’ve written will run on either a 3 or 4 series processor. All the source code is