开云体育

If Update_Names is a single digital input, then GetLastModifiedArrayIndex() will not return a usable value within its event handler. It is only defined for use with array signals. wrote:

Thanks for pointing to the right RackLink model. I got it working, it seems the "Control" user does not work or the password didnt set properly, or i cant log in through the web with that user either.

Thanks Lincoln for clarifying.? I guess we should include turning IGMP proxy off? as part of the initial setup of any system we set up.? Particularly on the series 3 with its 100baseT Ethernet

It’s digital versus analog. Digital is either 1 or 0. A PUSH is only gonna be high or low. A CHANGE is analog and can be any number. wrote: <http://www.tsav.com> Caleb Godfrey CTS Systems

Hi Lincoln, No Update_Names? is a single digital input. There are no other arrays in this module. I'll work around it but I think this behavior is a little strange. Thank you

IGMPPROXY is (potentially) helpful for lower-bandwidth multicast things like mDNS, UPnP, and Bonjour (AirPlay, AirPrint, etc.) bridging the CS to LAN – the problem is that the processor only has a

Is Update_Names an array? Do you have more than one input array? If no to the first question and yes to the 2nd see the SIMPL+ help “NOTE: Using GetLastModifiedArrayIndex OUTSIDE of an event (PUSH,

Hello, has anyone had issues with the Lutron QSX? i am using a mc4 with 2.500 fw and using he crestron module from app store for QSX, and i have control but the feedback is momentary, sometimes a

That is what I suspected would happen.? I have used IGMP proxy in conjunction with a mdns repeater in the routers we install to access Sonos from another subnet.? But that is more involved then

I'm sure this is way over simplifying it but... IGMP Proxy effectively forwards all IGMP traffic through the router. ?which means that the port the processor is plugged into would subscribe to all

Can someone explain why this always returns 1 PUSH Update_Names { Print("%s", NewNames[Getlastmodifiedarrayindex()]); } and this returns a proper index value CHANGE NewNames { Print("%s",

It does not work…and hasn’t worked for months and months since Dish made a change to how the boxes phone in to the mothership. I’ve been in contact with them once every few weeks to see what’s

Hi James L, For the Middle Atlantic RackLink Select Demo program, You can find the Crestron module in the files section (just posted a week or two ago). Also you can find it and the latest FW

Thanks for the confirmation.? I'll report back if there is any special VLAN configuration needed other than the standard IGMP Snooping/Querier and Multicast Router stuff.? I just remember way back

Sounds like a job for a PowerShell script with concurrent jobs! <Brian.Erchenbrecher@...> wrote:

We have systems running like this and they have been working well. The IT guys did the VLAN setup, so I don't know configuration specifics. In one case I have 10 TVs with RS232 control over the local

Hello, we are looking to control the Luxul PDU 8. All we need is sequence on and off control. I tried using MiddleAtlantic RacklinkSelect v1.0 module which compiles without error. Unlike the version

Oh, good to know. I will have to try that in this location at some point to see if that helps, and I'll definitely go that route in new deployments. We did just try the bit rate set to 300 Mbps on the

I found it

Updating the NVX system to the new 6.x firmware appears to have resolved this issue on our NVX-360s. [email protected]> wrote: