开云体育

Just out of curiosity, what would you want to control? I could see maybe wanting the connection PIN, but not much else.

Hi Phil, Debugger shows the output of the toggle as low when it should be high. If I shut the system down and start it again 9 times out of it will work correctly. I also swapped the toggle for an SR

That sounds almost as fun as the audio/video routing on the DMPS3-4K-200/300s. Crestron@...> wrote:

What does debugger say is happening? Crestron@...> wrote:

Hi Lincoln, The toggle is only fired by two steppers for different modes and a stepper for off. No other signals are driving it.

Not at all likely unless you have one heck of a lot of other stuff happening at the same time. The maximum number of signals that can change on a single logic wave is in the tens of thousands. If the

I made one a while back to control the routers via IP. Built it for the 72x144 but it would work for any size. Even polls and parses input, output names, and name of currently routed source to each

I had a good experience recently with Wyrestorm. 17 Transmitters and 35 receivers, with NEC displays connected thru receivers' RS232. A single Wyrestorm controller works as Crestron interface. Once

In SIMPL is there an easier way to convert an analog int to hex for a serial send than to take the analog, feed it into a divmod/16d then feeding the R&Q through an Analog Equate/Analog Initialize and

Martin, I have to admit that after looking at yours, it's definitely easier changing an int to Hex in Simpl+ lol...

I've heard mention of a Solstice module a few different times now. Either that Mersive is working on an 'official' Crestron partner module or that programmers are writing their own from the published

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the Crestron group. File : /Modules/Blackmagic VideoHub Control.zip Uploaded by :

I wrote a SIMPL+ module to control the videohub over rs422 last year, I will upload it to the files section in a few minutes. It is based on arrays, so if you need 72 outputs, just edit the variable

Putting this unit through the paces at the moment. I am already hammering Crestron about this, but thought I would post here as well. The help file says that valid inputs for the window sources are

Hi Guys, I have a strange issue with a CP3N. It is not operating a toggle consistently on shutdown. About every tenth shutdown it doesn't operate the toggle. I'm pulsing the toggle from a stepper.

So I'm working on updating the Blackmagic router module in the files section to work with more than 16 inputs. I have a VideoHub72 I'm trying to control. If anyone is interested in a copy of it,

Does anyone know of a brand of product that is easy to control with Crestron for the following scope? Scope: A head end Video IP encoder that has 16 HDMI inputs and transmits these 16 video signals

I've found that http://web-sniffer.net/ http://web-sniffer.net/ is helpful in seeing how to format your http requests

Ok, not really a programming question but... Anyone have any success in mounting a GLS-ODT-C-CN to an existing 2-gang box? In my garage (finished drywall) ceiling I have a 4 square box with a 2-gang

HTTP1.1 requires a Host: header at a minimum. The device may be expecting one or more additional headers as well -- those should be visible in your Wireshark request as well, or you can see them from