开云体育

Near camera will be selected whenever you are on camera 1 or 2, Video inputs down below what input you select drives the traffic of control. Put signals on it, watch it in debugger. From:

Literally Right now am fitting sub pages into a 6L from a 4SMD cause the company sold 2 Idocs in a project... -- *Jesus Tossas* * * *Technology Architect, Audio Engineer, Programmer* * *

I'm with you there...

Basically, the above. We've taken over an old analog distribution system, and recently replaced an old Fujitsu plasma w/ a large Samsung LED unit. No problem while on component distribution. We were

Honestly I hate to code Idocs...

Do you mean select near end camera to control camera 1, and then select near end camera again, and it toggles to camera 2 control?

Yep when you select the camera on the module it directs the command to the second camera. Done it bunch of times From: avsystemdesign <avsystemdesign@...<mailto:avsystemdesign@...>>

I am looking at the Polycom HDX 9000 v3.3.3 Crestron module, and not exactly sure how a person would control two Polycom Eagle Eye cameras connected up to the Codec?! Two local cameras that is. Has

That will only work for table dock, don't think will work for in wall. But yes for one siting on the desk will work. Crestron needs to come out with these quickly for lightning. But for that matter

Seth, you're saying to forgo the puck?

The non wall dock work fine, if you go from the cable that goes into dock, put that into lighting adaptor into iPhone or touch. You good. From: Bart Podkowka

Yes Airplay is fantastic, just stuff system with bunches of Apple Tvs, name them individually for family etc. No Control just message go to Airplay enabled device you good. MC3 pandora, airplay no,

Not to hijack the thread, but is anyone using AirPlay extensively? I have a few customers who use it via AppleTV, and chose to forego dedicated docks, but sometimes AirPlay devices don't show up as

Forget about wall dock and adapter. The iThingy won't fit Saludos, Regards, Mit freundlichen Gr眉脽en, Bart J. Podkowka CISoftware Mallorca Tel. +34 616273563

Try coolcontrol unit. It works better than direct comms. Saludos, Regards, Mit freundlichen Gr�遝n, Bart J. Podkowka CISoftware Mallorca Tel. +34 616273563 www.cisoftware.eu<http://www.cisoftware.eu>

It's been several months since the lightning iThingies have come out. I know there are various adapters available. Does anyone have any good/bad experience to share regarding IDOCs (wall mount) and

I thought you used to be able to just send serial text to that attribute and have it logged correctly, but apparently not. Digging around the RoomView demo program (available from the RVSE page, not

Not to hijack your thread, Heather, but if anyone knows the same thing for the MLX-2, it would be appreciated. I've got one that requires a hard button press to wake and another that issues the

Nevermind.... Ctrl+P in VTPRO

I had set my MLX-3s to require a hard button press to wake first, then press again to send a command. One of my clients is asking me to disable this, but I can't figure out where I set this. Anyone