开云体育

Qui ignore mes message d aide, tant pos pour lui...??? Envoyé depuis Yahoo Mail pour iPhone Le jeudi, ao?t 1, 2024, 10:29 AM, Ron Liekens <r.e.liekens@...> a écrit : David and Greg, I just got my radio second hand last week. The CAT problem showed on the first try. I tested HamRadioDeluxe, WSJT-X, FL-Digi (FL-Rig), RATS847 and some others. Omnirig does not give any reporting if things do not work right, but have checked with SDRconsole as a Tranceiver support, wich runs on Omnirig and its says that the FT-847 cannot be connected. As I see, the problem is always no feedback from the radio. WSJT-X gives an OK, but cannot show the frequency once it is connected as other radios do. It seems all is unidirectional even if an UNI.ini file is used, as Greg mentioned, that supports the FT-847 like in Omnirig and Hamlib. 73' Ron -- Yvan

Hello, Ron, I use SUCCI with FT847, Icom 725 and Icom 756pro3, never problem, use it with UCX Log and with satellite connection with SatPC32 without problems, many years. Vy 73 Yvan HB9C? Envoyé depuis Yahoo Mail pour iPhone Le dimanche, juillet 28, 2024, 1:44 PM, Ron Liekens <r.e.liekens@...> a écrit : Thanks for the reactions and possible solutions. The USB is reacting good to Windows 11 commands, but the FT-847 is not recognised by several softwares like FL-Digi, HamRadio Deluxe or WSJT-X. I tested it with standard RS-232 cable and O-modem serial cable, but no luck so far. I have a USB model with an FTDI chip on the way to be delivered later today. Also had an older one that also works with Windows 10 and 11, but sadly no luck with it. Mind you Windows has no problems with it and I used a serial connection software check-up that sees no problems with it. My radio is made in 1999, so I guess it is OK. 73' Ron -- Yvan

https://picclick.fr/SUCCI-Simple-USB-CAT-CW-Interface-280881362532.html Vy 73 Yvan HB9CSM Envoyé depuis Yahoo Mail pour iPhone Le dimanche, juillet 28, 2024, 12:13 PM, David Steele via groups.io <david_steele@...> a écrit : Hi Ron, WJ1I here and 73 from Cape Cod . I have a 847 running rock solid on CAT control. You cannot use the external tuner control and CAT at the same time...one or the other. Very important- you need a "null modem" cable or adapter between the pc and the radio . This swaps the rx and tx lines . Without this you'll get nothing! Next, as others have suggested, I strongly encourage using only FDTI chip set USB adapters. I've found https://www.startech.com/en-eu/cards-adapters/icusb2321f to be rock solid performers. Alternatively fit a pci rs232 card if using a desktop PC . 73 Dave Sent from my Verizon, Samsung Galaxy smartphone -------- Original message -------- From: Ron Liekens <r.e.liekens@...> Date: 7/27/24 6:04 AM (GMT-05:00) To: [email protected] Subject: [YaesuFT847] Serial cable question Hi, Can someone advise me a USB to serial RS-232 cable that works with the FT-847. I have a model with a Prolific230GT chip that does not connect. I have done several tests with a serial check software, and it seems to work ok. No luck with the FT-847 connecting tough. 73' Ron ON2RON -- Yvan

https://www.kotarov.com/projects/succi Vy 74 Yvan HB9CSM Envoyé depuis Yahoo Mail pour iPhone Le dimanche, juillet 28, 2024, 12:13 PM, David Steele via groups.io <david_steele@...> a écrit : Hi Ron, WJ1I here and 73 from Cape Cod . I have a 847 running rock solid on CAT control. You cannot use the external tuner control and CAT at the same time...one or the other. Very important- you need a "null modem" cable or adapter between the pc and the radio . This swaps the rx and tx lines . Without this you'll get nothing! Next, as others have suggested, I strongly encourage using only FDTI chip set USB adapters. I've found https://www.startech.com/en-eu/cards-adapters/icusb2321f to be rock solid performers. Alternatively fit a pci rs232 card if using a desktop PC . 73 Dave Sent from my Verizon, Samsung Galaxy smartphone -------- Original message -------- From: Ron Liekens <r.e.liekens@...> Date: 7/27/24 6:04 AM (GMT-05:00) To: [email protected] Subject: [YaesuFT847] Serial cable question Hi, Can someone advise me a USB to serial RS-232 cable that works with the FT-847. I have a model with a Prolific230GT chip that does not connect. I have done several tests with a serial check software, and it seems to work ok. No luck with the FT-847 connecting tough. 73' Ron ON2RON -- Yvan

Andrew, Good morning – I am finally getting back to my FT-847 troubleshooting. Yesterday, I performed the test of TP1003 and adjustment of T1009. I found that there is a maximum voltage of 0.572 which varies by adjusting T1009. Note that this voltage is present in RX or in TX (CW) – it just remains steady. So, what is the next step ? Thanks and 73, Steve W1SMS Steven M. Simons From: [email protected] <[email protected]> On Behalf Of Andrew Lenton Sent: Wednesday, October 11, 2023 5:25 PM To: [email protected] Subject: Re: [YaesuFT847] FT-847 only transmitting on FM mode. de: W1SMS Will do Get BlueMail for Android On 10 Oct 2023, at 21:14, Steven Simons <ssimons@...> wrote: Andrew, Nice to meet you and thanks for the repair tips. I do have a copy of the service manual - which I plan on reviewing prior to performing any adjustments. I'll probe the test points you refer to and see what I find. "stay tuned".... de: W1SMS

My FT-847 that is used on a weekly basis now has no receive yet meter is displaying full scale on any band and any mode except for FM. Looking for a repair tech. 73, de W2MSA

Dual Band HTs, HF + VHF + UHF Transceiver, Power Supply, Manuals, and more For Sale: . Yaesu FT-470 Dual Band HT: The innovative Yaesu FT-470 2M/440 HT has many sophisticated features, built into a robustly built chassis with easy-to-use external controls. It boasts four VFOs and 42 memories plus an impressive backlit dual band LCD. Power output can be as high at 5 watts depending on battery pack used. It has a very "tight" front end on the receiver, keeping a lot of intermod out. Features: 42 Memories 4 VFOs DTMF Keypad DTMF Auto Dialer Scanning Backlit Keypad CTCSS Encode Auto Repeater Shift Auto Power Off This particular unit works 100% and looks extremely nice. It has an aftermarket FNB-12, 12 volt 700 mahr battery pack. Also included is the dual band rubber duck antenna, wrist strap, wall charger, and paper work for $100 . Yaesu FT-60 Dual Band HT: The Yaesu FT-60R dual-band 2 meter/440 MHz HT has 5 watts output on both bands. It also features wideband receive from 108-520 and 700 to 999.990 MHz. It includes One touch NOAA weather, nine DTMF auto dialer memories, die-cast weather resistant case, ARTS Auto-range transponder system. 2.3 x 4.3 x 1.2 inches, 13.1 oz Features: Over 1000 Memories 5 Watts RF Output Backlit Keypad Alphanumeric Display NOAA Weather Alert PL Encode/Decode CS Encode/Decode Emergency Auto ID System This one works fine and looks fine. No scratches or defects. It includes rubber duck, belt clip, FNB-83 battery, charger, and paper work for $100 . Yaesu FT-847 HF+++ Transceiver: The Yaesu FT-847 changes base operation forever. Now you get three radios in one -- HF, VHF/UHF and satellite. You get 100 watt output on HF and 6 Meters, plus 50 watts on both 2 Meters and 430 MHz bands. Additional features include: Cross-band Full Duplex operation, Normal/Reverse Tracking, CTCSS/DCS Encode and Decode, 0.1 Hz tuning steps, DSP Notch, DSP NR and DSP BPF, Shuttle Jog Tuning Dial, Carry Handle and Keypad Entry. The FT-847 is also 1200/9600 bps Packet ready. 10.2 x 3.4 x 10.6 inches. Features: HF/VHF/UHF DSP Filters Dual Watch 0.1 Hz Tuning CTCSS/DCS Decode and Encoode Cross-band Full Duplex 1200/9600 Packet Ready It covers all of the normal ham bands in one package with virtually all modes! This one works 100% and looks like new. No defects. With paper work for $775. . Yaesu FP-707, 20 Amp Speaker/Power Supply: The Yaesu FP-707 is a 20 amp 13.8 Volt DC Power Supply, with a very nice front facing speaker in the same enclosure. Cosmetically, it matches the FT-707, FT-747, FT-757 and likely others. Electrically, it can provide up to 20 amps, so will work with most any HF and/or VHF rig. It also has a set of binding posts on the back for easy connection of a rig in addition to the HF rig. The speaker has a 3.5 mm plug on it. This particular unit is in very good shape both electrically and cosmetically. I can not find a scratch, dent, or ding on it. Electrically, it works as it should. Buy this unit with manual for $120. . Yaesu NC-9 B Charger 13 V DC at 45 ma, 2.5 mm plug; $12 . Original Yaesu Manuals: These are the manuals only. All are originals, and not copies. Most are in close to new condition. FNB-9,10,11,12 Battery packs, $2 FC-757AT Antenna Tuner, $10 FT-100 HF/VHF Transceiver, $18 FT-470 Dual Band HT, $10 FT-757 GX, HF Transceiver, $18 FT-720 R, 2 meter mobile, $8 FT-1802 M, 2 meter mobile, $12 FT-2700 Dual Band Xcvr, $12 FTH-2005 HT, $5 FTS-8 tone squelch unit, $3 FTS-12 tone squelch unit, $3 MH-1B A2B speaker microphone, $2 SP-101 P, Speaker / Phone patch, $5 VX-1 dual band HT, $10 Maintenance Service Manual for Yaesu FT-208 R 2 meter HT. Looks new. $25 Technical Supplement for Yaesu FT-2700 Dual Band Mobile. Looks new. $20 These are original Yaesu operating manuals only, in very nice condition. . I also have many other accessories available such as many different types of microphones, HTs, VHF and UHF rigs, HF and VHF/UHF antennas, connectors, miscellaneous accessories, etc. Just too many to list here. Please e-mail your requests. . Prices do not include shipping from Florida. Thanks. 73, Ken, W8EK Ke

what is a good procedure for removing the PA from the FTM100 motherboard? I have used solder wick to remove most of the solder but of course it is still attached. I have no special tools for that. Any ideas?

Hello all, I'm trying to research the capabilities of the use of the FT-847 with a transverter, requiring the use of 10 meters. The issue may be the requirement for opening transmit to 32 MHz to get to the top of the 2 meter band. For this transverter, 28 MHz = 144 MHz, and 32 MHz = 148 MHz. I know that it's possible to modify the FT-847 to transmit above 30 MHz, but I've seen reference to the low pass filter being a possible issue. Does anyone have experience with this, and are there any gotyas? Thanks, -- Cam, W4XXV

Has anyone had experience with using the digirig module with the FT847? Hal/WB4AEG

Can someone give me the Molex/Waldon part number for the power plug for the FT847 (and cord mounted socket for it if you know)? I see places that sell the cable but nowhere do I find the part number (even on the part) so I suspect they are Chinese clones. At any rate, does anyone know the part number for the power plug? Thank you. Jim Pruitt WA7DUY

Hey all. Just playing around with FT8 and reading up as much as I can. Many links and how to's mention that you just need the ALC to flicker. SO I have set the PWR meter set to ALC. So in regards to the ALC dos this mean I adjust the audio to the radio till I see the first couple of squares/bars come up during transmit/tune?

No! If I understand you right. You must set your radio settings how you want. This is not the same power as on the software. There is a scale you adjust this to change the audio level. I think it’s called the power level and it will bring your ALC down. You can have the ALC showing but set it low as you say or just disappearing but that’s your choice, personally I have mine showing a couple of bars Sent from Jeff M0UHF

Call????? Envoyé depuis Yahoo Mail pour iPad Le lundi, janvier 1, 2024, 03:34, Peter <vk2adg@...> a écrit : Hey all. Just playing around with FT8 and reading up as much as I can. Many links and how to's mention that you just need the ALC to flicker. SO I have set the PWR meter set to ALC. So in regards to the ALC dos this mean I adjust the audio to the radio till I see the first couple of squares/bars come up during transmit/tune? -- Yvan

Hey all. Tinkering around with an old (but newly aquired) 847 and doing what I like best and hooking up computers etc. I dont seem to be able to get any cat software to comminicate with the radio. is there a menu item somewhere that I have to turn on the cat control option in the radio? I see mention here and there googling it about a C+ or C- but not sure where that is. Any ideas welcomed