开云体育

I double checked and its the same for my 8900 and it works fine so I'm confused. I don't know if it's a delay issue and if someone knows what that number should be I would appreciate if you could

Morning John I just went to Tigertronics website, and they have cables and wiring instructions for both the Data and Packet ports. Hope this helps. Douglas

I've thought of using the mic input also. I don't know if my 847 is an early unit or not. I forget now but the serial number has to be G or later if I remember correctly. Doesn't matter because my

My 847 is an early model and I can’t use most digital for it. I didn’t find out in time to send it in for the update. However the only way I ever got packet to work is through the microphone

I am having the exact same problem. Packet works fine on FT-7900 vhf. Put the same cable into Packet Port on 847, keys up fine, tx fine, signal but no audio heard on another receiver. My understanding

I was wondering if you are using the DATA in/out port for the signal instead of the Packet port. Or maybe, the jumper block inside the signallink is wired slightly different. Just a

I have a Ft-847, signalink, and using agwpe but I am having problems with getting mine setup for FM packet.? I have everything working and confirm it works on my FT-8900 which successfully sends

Unfortunately my soldering iron packed it in so I haven't been able to remove that 2nd PC board the crystals are mounted on.? Notice the braille-like bumps on the ends of the silver cylinders.

That is unfortunate...?? I hope you can make a claim with mail service.? I wonder if it is at all salvageable

Guilty!? My parents could tell you horror stories (for them) about me taking apart things when I was very young.? :^)? And that's only the things they found out about. Hihi! But the story about

You must be one of those kids that always has to take things apart to see how they work HI HI 73, Mike

Ever wonder what the inside of a Collins mechanical filter looks like?

Hi. Try to run the radio full power only with a dummy load, and measure the voltage supply in Tx and Rx Modes. Make sure the voltages are within specs. The 847 has an over voltage protection. If you

Check your power supply connections. Loose connection are OK during receive, but during transmit, you will be a voltage drop resulting in all kinds of bad things happening including relay

In message <[email protected]>, Douglas Richards <ve3ffr@...> writes Closest I've had was the in-line fuse overheating, corroding and making poor contact. Mine were the

Hello All Has anyone had either of these 2 symptoms on their 847? When powering up or occasionally during operation to chatter or flicker causing you to restart controller software. I have had it,

Well somehow I managed to loose/misplace one of the 2 smaller rubber button inserts when I had the display unit disassembled for other repairs.? This was the Tuner Button Rubber insert in the face

Thanks Jerry-kn6cg

TNX??!!!! 73 ??????? ??? ??, 13 ????? 2020 ?-17:49 ??? ?Nils Ostman?? <? n.e.ostman@...??>:?

Q1134 can be found on the backside of the board near connector J1028.