开云体育

I am having trouble with tone scanning. When I try to set up tone scan, I first set squelch type to "T", then press the [F/W] key, then the [2(code)] key, then press and hold the [MHz up] key for one

Thanks Lawrence; I also understand that another problem can and does occur with the audio jack where xmit can occur when the plug isn't fully engaged; this has happened to me several times; first time

On the speaker issue; a friend had that problem after mishap. Further inside examination revealed the speaker jack was not making good contact therefore the speaker did not speak. Once he adjusted the

Gary; It sounds as if you may have a problem with a varactor built into the the chip controlling frequency. If that is the case then there is little that you can do but return the unit for repair or

After further experimentation, I have found that at full squelch the noise does go away on those high 70cm band freqs. So I have concluded that there is a problem with the squelch; I have to have the

Owen, It doesn’t matter where the squelch is set, I still get the noise on 70cm high end of the band. 448, 449 etc. the lower end of the band operates normally, and 2m works fine as well. Squelch

So what is your RF Squelch set to? (#37) Owen ________________________________ Sent: Tuesday, 24 May 2016 10:37 AM To: FT-60@... Subject: Re: [FT-60] Ft60 problem Yes it is new and occurs

Yes it is new and occurs wherever I go and is independent of antenna.

Is it a new noise and does it exist wherever you go?I was wondering it it could be electrical interference.

My FT-60r has constant noise on the high end of 70cm band? Squelch doesn't remove it

That should be allow to remove what is assigned without causing any problem. > Ken

With the cable unplugged from a usb port, Win 10 will change it to what ever is in the registry. Nirsoft's USB VIEW will tell and allow you to change what is there. Good program to shoot usb port

My windows 10 computer will periodically change comports for unknown reasons, which confuses the FT Commander. Apparently, this is all part of the computer's strategy to keep me from falling asleep at

Go to Windows Control Panel, click on Device Manager, then click on the "+" sign next to "Ports." 73, Jim K5JG

On a windows computer, go to Control panel, system, device manager, ports.? This should give you what port is being used by your cable.? If more than one device shows up and you are not sure, unplug

Hi Go to Control Panel then select Device Manager Look down the list for Ports (COM & LPT) Extend this list and this will show all your ports in use. If you remove the USB cable then connect again you

ha, when I did it, it gave me a choice.... I selected incorrectly but made up for it by physically switching the plug to the other port and so I have to remember which one I plug into.? Not very

How do I know what port I'm using for Commander, I'm using a USB cable? confused.

Handheld tape measure beams/yagis are an inexpensive way to get into the world of high gain with your HTs. Heck, I turned my TX power DOWN to 2W to speak with ISS Commander Wiseman two Field Days ago

You can use Boot Camp and install Windows on your Mac.