Re: Programming with Commander
|
Hi
Go to Control Panel then select Device Manager Look down the list for Ports (COM & LPT) Extend this list and this will show all your ports in use. If you remove the USB cable then connect again you should see which port you are connecting too.
Hope this helps
Dave 2E0OAI
On 12 May 2016 at 02:14, gene.reif@... [FT-60] <FT-60@...> wrote:
?
How do I know what port I'm using for Commander, I'm using a USB cable?? confused.
--
DISCLAIMER
The contents of this e-mail are for use by the intended addressee(s) only. Please note that if you are not the intended recipient of this e-mail, any dissemination, distribution or copying of this e-mail by you is strictly prohibited and you must not read, use or take any action in reliance on it. If you have received this e-mail in error, please immediately notify the sender by return e-mail.? Please note that the sender accepts no responsibility for viruses and it is your responsibility to scan any attachments.
|
